A.Cisco
B.ANSI-Annex D
C.Q.931-Annex B
D.Q.933-Annex A
您可能感興趣的試卷
你可能感興趣的試題
A.An update packet with init flag set from a known， already established neighbor relationship was received by one of the routers.
B.The ARP cache was cleared.
C.The counters were cleared.
D.The IP EIGRP neighbor relationship was cleared manually.
A.hostname
B.loopback address
C.default gateway
D.domain name
E.SSH peer address
A.Configure the EtherChannel as "desirable" first.
B.Assign all interfaces to the same VLAN.
C.Disable PortFast on the interfaces in the EtherChannels.
D.Disable all interfaces first.
E.Fast Ethernet and Gigabit Ethernet ports cannot be assigned to the same EtherChannel.
F.Fix cabling problems.
A.Tunnel IPv6 over IPv4 to connect far-end IPv6 networks.
B.Explain why configuring IPv4 and IPv6 at the same time over the same LAN interface is not possible.
C.Explain why configuring IPv4 and IPv6 at the same time over the same LAN interface is possible.
D.What is the meaning of EUI-64 and how does it work？
E.Tunnel IPv4 over IPv6 to connect far-end IPv4 networks.
A.EIGRP will not be accepted when configured on the actual RIPv2 routers.
B.OSPF will no longer be used in the routing table， because you only have EIGRP internal routes running.
C.OSPF will no longer be used in the routing table， because you only have EIGRP external routes running.
D.RIPv2 will populate its RIP database but not its routing table， because you only have EIGRP external routes running.
E.RIPv2 will populate its RIP database but not its routing table， because you only have EIGRP internal routes running.
F.OSPF database will have RIPv2 routes.
A.The trunking configuration mode on Switch1 is set to Off.
B.The trunking configuration mode on the other end is set to On.
C.The trunking configuration mode on the other end is set to Desirable.
D.Cisco Discovery Protocol is not running on the other end.
E.There is a VTP domain name mismatch.
F.Switch1 does not support 802.1Q
A.BGP peers must be Layer 2-adjacent.
B.EBGP multihop is not configured.
C.The firewall is not configured to allow IP protocol 89.
D.The firewall is not configured to allow UDP 179.
A.route redistribution
B.import and export using route descriptors
C.import and export using route targets
D.Cisco MPLS Traffic Engineering
A.CEF
B.FIB
C.LFIB
D.IGP
A.interface bandwidth
B.interface delay
C.interface bandwidth and delay
D.hop count
E.bridge priority
最新試題
You are the network administrator of a Layer 3 switched network. Users in one VLAN are complaining that access to the server VLAN is very slow from time to time. Traffic in the local VLAN works without any issue， and users in other VLANs do not have any complaint to reach the server VLAN. What is most likely the cause of this issue？（）
Which three protocols should be explicitly managed by using Control Plane Policing on an Internet border router？（）
Which two attributes need to match for two switches to become members of the same MST region？ （）
What does the OSPF command capability vrf-lite achieve？（）
Which QoS mechanism can help classify different kinds of Citrix traffic （print job versus real-time terminal control）？（）
Choose two commands that are required to enable multicast on a router， when it is known that the receivers use a specific functionality of IGMPv3.（）
Which statement best describes OSPF external LSAs （type 5）？（）
Which router is doing LSA type 7 to type 5 translation，and why？（）
What are the "bound IP addresses" used for in LDP？（）
Multicast is being deployed in the network， and only ip pim sparse-dense mode has been configured on all interfaces in the network to support a new video streaming application. No other multicast configuration was applied anywhere in the network. Since enabling multicast， the network monitoring tools show periodic spikes in link utilization throughout the network， even in areas where the video application is not being used. What could be a possible cause？（）