A.hostname
B.loopback address
C.default gateway
D.domain name
E.SSH peer address
您可能感興趣的試卷
你可能感興趣的試題
A.Configure the EtherChannel as "desirable" first.
B.Assign all interfaces to the same VLAN.
C.Disable PortFast on the interfaces in the EtherChannels.
D.Disable all interfaces first.
E.Fast Ethernet and Gigabit Ethernet ports cannot be assigned to the same EtherChannel.
F.Fix cabling problems.
A.Tunnel IPv6 over IPv4 to connect far-end IPv6 networks.
B.Explain why configuring IPv4 and IPv6 at the same time over the same LAN interface is not possible.
C.Explain why configuring IPv4 and IPv6 at the same time over the same LAN interface is possible.
D.What is the meaning of EUI-64 and how does it work?
E.Tunnel IPv4 over IPv6 to connect far-end IPv4 networks.
A.EIGRP will not be accepted when configured on the actual RIPv2 routers.
B.OSPF will no longer be used in the routing table, because you only have EIGRP internal routes running.
C.OSPF will no longer be used in the routing table, because you only have EIGRP external routes running.
D.RIPv2 will populate its RIP database but not its routing table, because you only have EIGRP external routes running.
E.RIPv2 will populate its RIP database but not its routing table, because you only have EIGRP internal routes running.
F.OSPF database will have RIPv2 routes.
A.The trunking configuration mode on Switch1 is set to Off.
B.The trunking configuration mode on the other end is set to On.
C.The trunking configuration mode on the other end is set to Desirable.
D.Cisco Discovery Protocol is not running on the other end.
E.There is a VTP domain name mismatch.
F.Switch1 does not support 802.1Q
A.BGP peers must be Layer 2-adjacent.
B.EBGP multihop is not configured.
C.The firewall is not configured to allow IP protocol 89.
D.The firewall is not configured to allow UDP 179.
A.route redistribution
B.import and export using route descriptors
C.import and export using route targets
D.Cisco MPLS Traffic Engineering
A.CEF
B.FIB
C.LFIB
D.IGP
A.interface bandwidth
B.interface delay
C.interface bandwidth and delay
D.hop count
E.bridge priority
A.mark VOIP traffic with IP precedence 6 and configure only ’fair-queue’ on the links
B.configure the scheduler allocate 3000 1000 command to allow the QoS code to have enough CPU cycles
C.enable class-based traffic shaping on the VoIP traffic class
D.enable Layer 2 fragmentation and interleaving on the links
E.enable Frame Relay on the links and send voice and data on different Frame Relay PVCs
A.Designated Root Cost
B.bridge ID priority
C.max age
D.bridge ID MAC address
E.Designated Root Priority
F.forward delay
最新試題
For the following ports, which port is on every bridge in a Spanning Tree Protocol IEEE 802.1w network except the root bridge?()
Which message type is constructed and sent from an MSDP router to its MSDP peers when it receives a PIM register message (knowing that the MSDP router is also configured as an RP for the PIM domain)?()
When a BGP router is not capable of understanding 4-byte AS numbers, it will see 4-byte AS numbers as a special, reserved, 2-byte AS number in the AS path. Which 2-byte AS number is this reserved one?()
What is the command to configure RSVP to reserve up to one-tenth of a Gigabit link, but only allow each individual flow to use 1 MB/s?()
What does a unicast prefix-based IPv6 multicast address start with?()
Which statement is correct about an OSPF sham-link?()
What are the "bound IP addresses" used for in LDP?()
IEEE 802.1w is a Rapid Spanning Tree Protocol (RSTP) that can be seen as an evolution of the 802.1 standard. What are the port roles described by 802.1w?()
Which router is doing LSA type 7 to type 5 translation,and why?()
Two directly connected routers, R1 and R2, are both configured for OSPF graceful restart. R2 is able to switch packets in hardware, but R1 is not. If a network administrator logs on to R2 and performs a system reload, which will be the result?()