A.Source-Active Message
B.PIM Join
C.PIM Hello
D.MSDP Register
您可能感興趣的試卷
你可能感興趣的試題
A.FF80
B.FF3
C.FF
D.FF7
A.VRF definition for IPv6
B.MP BGP for IPv6
C.LDP
D.VRF-enabled routing protocol
E.VRF-enabled interface
A.Out-of-profile packets are queued.
B.It causes TCP retransmits.
C.Marking and remarking are not supported.
D.It does not respond to BECN and foresight messages.
E.It uses a single- and two-bucket mechanism for metering.
A.change the EtherChannel default hashing algorithm from XOR to use source port Layer 4 port load balancing to better load balance the traffic
B.change the EtherChannel default hashing algorithm from XOR to use destination Layer 4 port load balancing to better load balance the traffic
C.have the application recoded to use multiple connections instead of a single connection so EtherChannel can better load balance the traffic
D.upgrade the CPU and memory of the compute devices so they can better process traffic
E.upgrade the EtherChannel bundle to a single gigabit link because EtherChannel is not well suited for single-connection traffic
A.the table of 4096 elements that map the respective VLAN to STP instance number
B.VTP version
C.configuration revision number
D.native VLAN ID
A.PIM sparse mode is being used.
B.PIM dense mode is being used.
C.The BGP multicast address family has not been configured.
D.IGMP version 3 is being used.
E.IP PIM neighbor filters have not been applied.
A.The phones are not sending traffic with the correct DSCP value.
B.The Cisco CallManager is not marking the traffic correctly.
C.This is most likely a bug on the CE routers.
D.Your LAN QoS is incorrectly configured.
A.routing issue
B.denial-of-service attack
C.MAC flooding
D.spanning-tree recalculation
E.Layer 2 loop
F.ARP spoofing attack
A.LDAP
B.ICMP
C.RTP
D.BGP
E.SSH
F.RDP
A.qos-group
B.DSCP
C.LFI
D.NBAR
最新試題
Choose two commands that are required to enable multicast on a router， when it is known that the receivers use a specific functionality of IGMPv3.（）
IEEE 802.1w is a Rapid Spanning Tree Protocol （RSTP） that can be seen as an evolution of the 802.1 standard. What are the port roles described by 802.1w？（）
Two directly connected routers， R1 and R2， are both configured for OSPF graceful restart. R2 is able to switch packets in hardware， but R1 is not. If a network administrator logs on to R2 and performs a system reload， which will be the result？（）
Which two attributes need to match for two switches to become members of the same MST region？ （）
What is the command to configure RSVP to reserve up to one-tenth of a Gigabit link， but only allow each individual flow to use 1 MB/s？（）
For the following ports， which port is on every bridge in a Spanning Tree Protocol IEEE 802.1w network except the root bridge？（）
Which statement is correct about an OSPF sham-link？（）
Which message type is constructed and sent from an MSDP router to its MSDP peers when it receives a PIM register message （knowing that the MSDP router is also configured as an RP for the PIM domain）？（）
Which three are needed to run VRF lite for IPv6 on a router？ （）
When a BGP router is not capable of understanding 4-byte AS numbers， it will see 4-byte AS numbers as a special， reserved， 2-byte AS number in the AS path. Which 2-byte AS number is this reserved one？（）