A.EIGRP will not be accepted when configured on the actual RIPv2 routers.
B.OSPF will no longer be used in the routing table， because you only have EIGRP internal routes running.
C.OSPF will no longer be used in the routing table， because you only have EIGRP external routes running.
D.RIPv2 will populate its RIP database but not its routing table， because you only have EIGRP external routes running.
E.RIPv2 will populate its RIP database but not its routing table， because you only have EIGRP internal routes running.
F.OSPF database will have RIPv2 routes.
您可能感興趣的試卷
你可能感興趣的試題
A.The trunking configuration mode on Switch1 is set to Off.
B.The trunking configuration mode on the other end is set to On.
C.The trunking configuration mode on the other end is set to Desirable.
D.Cisco Discovery Protocol is not running on the other end.
E.There is a VTP domain name mismatch.
F.Switch1 does not support 802.1Q
A.BGP peers must be Layer 2-adjacent.
B.EBGP multihop is not configured.
C.The firewall is not configured to allow IP protocol 89.
D.The firewall is not configured to allow UDP 179.
A.route redistribution
B.import and export using route descriptors
C.import and export using route targets
D.Cisco MPLS Traffic Engineering
A.CEF
B.FIB
C.LFIB
D.IGP
A.interface bandwidth
B.interface delay
C.interface bandwidth and delay
D.hop count
E.bridge priority
A.mark VOIP traffic with IP precedence 6 and configure only ’fair-queue’ on the links
B.configure the scheduler allocate 3000 1000 command to allow the QoS code to have enough CPU cycles
C.enable class-based traffic shaping on the VoIP traffic class
D.enable Layer 2 fragmentation and interleaving on the links
E.enable Frame Relay on the links and send voice and data on different Frame Relay PVCs
A.Designated Root Cost
B.bridge ID priority
C.max age
D.bridge ID MAC address
E.Designated Root Priority
F.forward delay
A.service timestamps log datetimec msec
B.logging timestamps msec
C.syslog timestamps hour minute second miliseconds
D.service logging timestamp msec
E.logging service timestamp msec
A.ip sla monitor low-memory
B.ip sla group schedule
C.ip sla reaction-trigger
D.ip sla enable timestamp
A.Upgrade the switches
B.Configure BPDU guard
C.Configure VLAN access lists
D.Configure port security
E.Configure Dynamic ARP inspection
最新試題
Which message type is constructed and sent from an MSDP router to its MSDP peers when it receives a PIM register message （knowing that the MSDP router is also configured as an RP for the PIM domain）？（）
Which statement best describes OSPF external LSAs （type 5）？（）
Which statement is correct about an OSPF sham-link？（）
What does the OSPF command capability vrf-lite achieve？（）
When two bridges are competing for the root bridge of an IEEE 802.1D spanning tree and both have the same bridge priority configured， which parameter determines the winner？（）
When a BGP router is not capable of understanding 4-byte AS numbers， it will see 4-byte AS numbers as a special， reserved， 2-byte AS number in the AS path. Which 2-byte AS number is this reserved one？（）
Which IOS security feature is configured by the ip inspect inspection-name {in out} command？（）
Which three protocols should be explicitly managed by using Control Plane Policing on an Internet border router？（）
Multicast is being deployed in the network， and only ip pim sparse-dense mode has been configured on all interfaces in the network to support a new video streaming application. No other multicast configuration was applied anywhere in the network. Since enabling multicast， the network monitoring tools show periodic spikes in link utilization throughout the network， even in areas where the video application is not being used. What could be a possible cause？（）
IEEE 802.1w is a Rapid Spanning Tree Protocol （RSTP） that can be seen as an evolution of the 802.1 standard. What are the port roles described by 802.1w？（）