A.An update packet with init flag set from a known， already established neighbor relationship was received by one of the routers.
B.The ARP cache was cleared.
C.The counters were cleared.
D.The IP EIGRP neighbor relationship was cleared manually.
您可能感興趣的試卷
你可能感興趣的試題
A.hostname
B.loopback address
C.default gateway
D.domain name
E.SSH peer address
A.Configure the EtherChannel as "desirable" first.
B.Assign all interfaces to the same VLAN.
C.Disable PortFast on the interfaces in the EtherChannels.
D.Disable all interfaces first.
E.Fast Ethernet and Gigabit Ethernet ports cannot be assigned to the same EtherChannel.
F.Fix cabling problems.
A.Tunnel IPv6 over IPv4 to connect far-end IPv6 networks.
B.Explain why configuring IPv4 and IPv6 at the same time over the same LAN interface is not possible.
C.Explain why configuring IPv4 and IPv6 at the same time over the same LAN interface is possible.
D.What is the meaning of EUI-64 and how does it work？
E.Tunnel IPv4 over IPv6 to connect far-end IPv4 networks.
A.EIGRP will not be accepted when configured on the actual RIPv2 routers.
B.OSPF will no longer be used in the routing table， because you only have EIGRP internal routes running.
C.OSPF will no longer be used in the routing table， because you only have EIGRP external routes running.
D.RIPv2 will populate its RIP database but not its routing table， because you only have EIGRP external routes running.
E.RIPv2 will populate its RIP database but not its routing table， because you only have EIGRP internal routes running.
F.OSPF database will have RIPv2 routes.
A.The trunking configuration mode on Switch1 is set to Off.
B.The trunking configuration mode on the other end is set to On.
C.The trunking configuration mode on the other end is set to Desirable.
D.Cisco Discovery Protocol is not running on the other end.
E.There is a VTP domain name mismatch.
F.Switch1 does not support 802.1Q
A.BGP peers must be Layer 2-adjacent.
B.EBGP multihop is not configured.
C.The firewall is not configured to allow IP protocol 89.
D.The firewall is not configured to allow UDP 179.
A.route redistribution
B.import and export using route descriptors
C.import and export using route targets
D.Cisco MPLS Traffic Engineering
A.CEF
B.FIB
C.LFIB
D.IGP
A.interface bandwidth
B.interface delay
C.interface bandwidth and delay
D.hop count
E.bridge priority
A.mark VOIP traffic with IP precedence 6 and configure only ’fair-queue’ on the links
B.configure the scheduler allocate 3000 1000 command to allow the QoS code to have enough CPU cycles
C.enable class-based traffic shaping on the VoIP traffic class
D.enable Layer 2 fragmentation and interleaving on the links
E.enable Frame Relay on the links and send voice and data on different Frame Relay PVCs
最新試題
For the following items，what is the mathematical relationship between the committed information rate （CIR）， committed burst （Bc）， and committed rate measurement interval （Tc）？（）
Which three statements are true about policing？ （）
Policy-based routing allows network administrators to implement routing policies to allow or deny paths based on all of these factors except which one？（）
Internet Protocol version 6 （IPv6） is the next-generation Internet Layer protocol for packet-switched internetworks and the Internet. IPv6 router solicitation is（）
Choose two commands that are required to enable multicast on a router， when it is known that the receivers use a specific functionality of IGMPv3.（）
Which three protocols should be explicitly managed by using Control Plane Policing on an Internet border router？（）
f a Cisco switch is configured with VTPv1 in transparent mode， what is done with received VTP advertisements？（）
What are the "bound IP addresses" used for in LDP？（）
IEEE 802.1w is a Rapid Spanning Tree Protocol （RSTP） that can be seen as an evolution of the 802.1 standard. What are the port roles described by 802.1w？（）
For the following protocols， which one provides a mechanism to transparently intercept and redirect CIFS traffic from a client to a local Cisco Wida Area Application engine？（）