A.A request made by a node for the IP address of the local router
B.A request made by a node to join a specified multicast group
C.A request made by a node for a DHCP provided IP address
D.A request made by a node for the IP address of the DHCP server
您可能感興趣的試卷
你可能感興趣的試題
A.2031：0：130F：0：0：09C0：876A：130B
B.2031：：130F：：9C0：876A：130B
C.2031：0：130F：：9C0：876A：130B
D.2031：0：130F：0：0：9C0：876A：130B
A.Traffic forwarded from R2 to or through R1 will continue to be forwarded based on the forwarding table state at the time of the reload.
B.R2 will continue to forward traffic to R1， but R1 will drop the traffic because its neighbor adjacency with R2 has failed.
C.R2 will continue forwarding traffic to and through R1， but R1 will drop this traffic because it is not capable of maintaining its forwarding state.
D.All the traffic R2 is forwarding to or through R1 will be dropped while OSPF rebuilds its neighbor adjacency and forwarding tables.
A.It ensures that BPDUs sent by the root bridge are forwarded in a timely manner
B.It enforces the root bridge placement in the network
C.It ensures that all ports receiving BPDUs from the root bridge are in the forwarding state.
D.It ensures that the bridge is elected as root bridge in the network.
A.IPv6 multicast uses Multicast Listener Discovery.
B.The first 8 bits of an IPv6 multicast address are always FF （1111 1111）.
C.IPv6 multicast requires MSDP.
D.PIM dense mode is not part of IPv6 multicast.
A.Sent by the destination
B.Received by the sender
C.Received by the destination
D.Sent by the sender
A.Only UplinkFast and BackboneFast are specified in 802.1w； PortFast must be manually configured.
B.Only PortFast is specified in 802.1w； UplinkFast and BackboneFast must be manually configured.
C.None of the proprietary Cisco enhancements are specified in 802.1w.
D.PortFast， UplinkFast， and BackboneFast are specified in 802.1w.
A.Speed mismatch
B.Incorrect encapsulation
C.MTU set too low
D.Duplex mismatch
A.EBGP multihop will need to be configured for this to work.
B.This should work with normal BGP peering， with no additional configuration on the BGP speakers or the firewall.
C.The BGP protocol port must be opened on the firewall
D.There is no way to make BGP work across a firewall.
A.The stack bit will only be used when LDP is the label distribution protocol
B.The label is the last entry in the label stack.
C.The stack bit is for Cisco implementations exclusively and will only be used when TDP is the label distribution protocol.
D.The stack bit is reserved for future use.
A.Reverse Path Forwarding
B.Hardware-based forwarding
C.UDP forwarding
D.Layer 2 Forwarding
最新試題
What does a unicast prefix-based IPv6 multicast address start with？（）
Which statement is correct about an OSPF sham-link？（）
f a Cisco switch is configured with VTPv1 in transparent mode， what is done with received VTP advertisements？（）
You are the network administrator of a Layer 3 switched network. Users in one VLAN are complaining that access to the server VLAN is very slow from time to time. Traffic in the local VLAN works without any issue， and users in other VLANs do not have any complaint to reach the server VLAN. What is most likely the cause of this issue？（）
Policy-based routing allows network administrators to implement routing policies to allow or deny paths based on all of these factors except which one？（）
Which three statements are true about policing？ （）
Multicast is being deployed in the network， and only ip pim sparse-dense mode has been configured on all interfaces in the network to support a new video streaming application. No other multicast configuration was applied anywhere in the network. Since enabling multicast， the network monitoring tools show periodic spikes in link utilization throughout the network， even in areas where the video application is not being used. What could be a possible cause？（）
For the following ports， which port is on every bridge in a Spanning Tree Protocol IEEE 802.1w network except the root bridge？（）
For the following protocols， which one provides a mechanism to transparently intercept and redirect CIFS traffic from a client to a local Cisco Wida Area Application engine？（）
Which three are needed to run VRF lite for IPv6 on a router？ （）