單項選擇題For lasers with tightly controlled wavelengths, approximately how far apart are the centers of adjacent wavelengths when 100 GHz spacing is used in a DWDM system?（）

A. 0.4 nanometers
B. 0.6 nanometers
C. 0.8 nanometers
D. 1.2 nanometers
E. 1.6 nanometers


您可能感興趣的試卷

你可能感興趣的試題

1.單項選擇題If the power is 0 dBm, what is the power in mW?（）

A.0mW
B.1mW
C.10mW
D.1.5mW

2.單項選擇題Which device creates an OEO conversion?（）

A. amplifier
B. attenuator
C. regenerator
D. light emitter
E. optical switch
F. optical receiver
G. fiber-optic cable

4.多項選擇題What three in combination are factors that can cause four-wave mixing in fiber-optic cables? （）(Choose three.)

A. low optical power
B. high optical power
C. few optical channels
D. many optical channels
E. low chromatic dispersion
F. high chromatic dispersion
G. too much power differential in the optical channels

5.單項選擇題Why are the 1300 nm and 1550 nm regions of the fiber spectrum primarily used for optical communications?（）

A. They are both regions of lowest loss.
B. They are both regions of low reflections.
C. They are both regions of low index of refraction.
D. They are both regions of low chromatic dispersion.
E. They are both regions of low Polarization Mode Dispersion (PMD).

6.單項選擇題What is an advantage of an externally modulated laser over a directly modulated laser?（）

A. lower cost
B. higher chirp
C. easier to manufacture
D. higher dispersion tolerance
E. higher optical signal-to-noise ratio

7.單項選擇題What is the difference between the transmitted power and the sensitivity of the receiver?（）

A. OSNR
B. dispersion
C. attenuation
D. power budget
E. amplifier spacing
F. four wave mixing

8.多項選擇題Which three technologies are used to reduce chromatic dispersion accumulation in fiber-optic transmission systems? （）(Choose three.)

A. PIN photodiodes
B. zero-chirped lasers
C. Erbium-doped fiber amplifiers
D. dispersion compensating fiber
E. dispersion compensating Bragg grating