單項選擇題Given the formula: (Fiber Attenuation * Km) + (Splice Attenuation * # of Splices) + (Connector Attenuation * # of Connectors) + (Optical Fiber or OADM) + Buffer(Fiber aging)) With regard to SONET/SDH optical calculations, what will the given formula provide?（）

A. fiber loss
B. OSNR level
C. post amplification
D. index of reflection
E. index of refraction
F. power post amplification budget


您可能感興趣的試卷

你可能感興趣的試題

1.多項選擇題What three in combination are factors that can cause four-wave mixing in fiber-optic cables? （）(Choose three.)

A. low optical power
B. high optical power
C. few optical channels
D. many optical channels
E. low chromatic dispersion
F. high chromatic dispersion
G. too much power differential in the optical channels

2.單項選擇題Why are the 1300 nm and 1550 nm regions of the fiber spectrum primarily used for optical communications?（）

A. They are both regions of lowest loss.
B. They are both regions of low reflections.
C. They are both regions of low index of refraction.
D. They are both regions of low chromatic dispersion.
E. They are both regions of low Polarization Mode Dispersion (PMD).

3.單項選擇題What is an advantage of an externally modulated laser over a directly modulated laser?（）

A. lower cost
B. higher chirp
C. easier to manufacture
D. higher dispersion tolerance
E. higher optical signal-to-noise ratio

4.單項選擇題What is the difference between the transmitted power and the sensitivity of the receiver?（）

A. OSNR
B. dispersion
C. attenuation
D. power budget
E. amplifier spacing
F. four wave mixing

5.多項選擇題Which three technologies are used to reduce chromatic dispersion accumulation in fiber-optic transmission systems? （）(Choose three.)

A. PIN photodiodes
B. zero-chirped lasers
C. Erbium-doped fiber amplifiers
D. dispersion compensating fiber
E. dispersion compensating Bragg grating

9.多項選擇題What are two important considerations when using 2- or 4-channel 15216 OADMs?（） (Choose two.)

A. All "Add" channels require uniform power levels.
B. The flexibility of wavelengths per OADM is limited.
C. It is easier to balance "Pass-Through" and "Add" channels.
D. There is lower pass-through loss using multi-channel OADMs.
E. You can extract a single channel without dropping other channels.