A.line timing
B.loop timing
C.internal timing
D.through timing
E.external timing
您可能感興趣的試卷
你可能感興趣的試題
A.2
B.3
C.4
D.20
E.22
F.24
A. VT circuits
B. STS circuits
C. VT tunnel circuits
D. 1:1 protection circuits
E. 1:N protection circuits
Click the Exhibit button. Given the information shown in the exhibit, when creating 2 DS1 circuits, how many STS ports are used on the VT1.5 matrix at Node 1 as VT circuits and how many are used after using VT tunnels?（）
A.2；0
B.3；2
C.3；5
D.4；0
E.6；0
F.6；2
A. Slot 2 and Slot 4
B. Slot 4 and Slot 6
C. Slots 5 or 13 only
D. Slot 16 and Slot 17
Click the Exhibit button. Which type of protection is shown in the exhibit?（）
A.1+0
B.1+1
C.1：1
D.1：N
A.0
B.1
C.2
D.3
E.4
A. signal fail, signal degrade, manual switch
B. signal degrade, signal fail, manual switch
C. protection lockout, manual switch, path AIS
D. forced switch, manual switch, signal degrade
E. protection lockout, manual switch, forced switch
A. Switch times would exceed 50 ms for an OC-3 BLSR ring.
B. An equal amount of working and protect bandwidth is required.
C. DCC bandwidth is not large enough to handle K1/K2 processing.
D. There is not enough bandwidth in an OC-3 ring to justify BLSR protection.
A. It protects signals against node failures between rings.
B. It protects signals against node failure within a single ring.
C. It allows for traffic to be preempted when a ring switch occurs.
D. Traffic can be dropped and continued at interconnecting nodes.
E. It protects preemptible traffic from being dropped when a ring switch occurs.
A.LEX
B.HDLC
C.GFP-F
D.PPP/BCP
最新試題
What are three relevant design considerations when using the 15216 EDFA? （）(Choose three.)
Click the Exhibit button. When designing a DWDM system with multiple amplified spans, a pre-amp is needed at Site B to （）. (Choose three.)
If the dispersion of a given fiber is 17ps/nm*km at 1550 nm and zero at 1310 nm, then what is the accumulated dispersion of an ITU wavelength after it travels 200 km?（）
If the power is 0 dBm, what is the power in mW?（）
Scrambling of SONET signals is done to （）.
Which is a legitimate bandwidth matched pair?（）
UPSR protection switching is initiated by （）, while BLSR is initiated by （）.
Click the Exhibit button. The exhibit shows a 15454/15216 DWDM system and alarm indications. What are two possible sources of trouble shown in the system?（） (Choose two.)
For lasers with tightly controlled wavelengths, approximately how far apart are the centers of adjacent wavelengths when 100 GHz spacing is used in a DWDM system?（）
In order to avoid misconnections due to a failed node in a Bidirectional Line Switched Ring (BLSR), Alarm Indication Signals (AISs) are sent on every channel normally terminating in that node. What is the name of this process?（）