A.enable aggressive load balancing
B.enable coverage hole detection
C.disable dynamic transmit power control
D.enable short preamble
您可能感興趣的試卷
你可能感興趣的試題
A.nominally 30 percent to best align with Cisco Unified Communications System recommendations
B.100 percent to ensure that the VoWLAN calls can use all the available bandwidth, if needed
C.system default of 75 percent
D.40 to 60 percent
E.voice CAC should be left disabled unless wired QoS is configured
A.configure WLAN setting to enable WMM
B.configure WLAN Aironet information elements enabled
C.configure global 802.11b/g or 802.11a,or both,voice CAC
D.configure WLAN QoS Platinum
E.configure DTIM = 2
A.on any of the queues
B.AC_VO
C.AC_VI
D.the strict priority queue
A.synchronization of the transmission and reception of voice frames
B.bandwidth reservation
C.optimized power-save mode periods
D.increased call capacity
E.priority bandwidth and polling
A.AC_VI
B.AC_VO
C.AC_BK
D.AC_BE
A.CS3
B.CS1
C.EF
D.5
E.6
A.***
B.**#
C.**1
D.**2
A.Disable DTPC on the radio.
B.Disable higher data rates on the radio.
C.Disable WMM policy on the WLAN.
D.Disable multicast on the WLAN.
A.Wireless client WMM UP classification is translated to a wired DSCP priority.
B.Wireless client 802.11p classification is translated to a wired DSCP priority.
C.Wireless client WMM UP classification is translated to a wired 802.1p CoS priority.
D.Wireless client 802.11p classification is translated to a wired 802.1p CoS priority.
E.WLAN configured QoS level is used to set the wired DSCP priority.
F.Wired 802.1p CoS priority is not set.
A.Platinum
B.Gold
C.Silver
D.Bronze
最新試題
What is the payload size of a wireless IP phone in a call using G.711 codec?()
What is the bandwidth requirement of an active duplex wireless call using G.711 codec?()
Which two EAP types does the Cisco Unified Wireless IP Phone 7921G firmware code version 1.3(x) support?()
Which three WLC items are required to properly enable queuing with TSPEC for voice traffic?()
An LWAPP encapsulated packet is being sent from the Cisco WLC v5.2 to the AP for a wireless WMM client. Can the LWAPP frame be altered to change the resulting final WMM queue for transmission on an 802.11 client?()
What call performance statistics are reported on the Cisco Wireless IP Phone 7921 user interface?()
Which configuration should be done in order to improve the performance of the Cisco Unified Wireless IP Phone 7921G in a WLAN infrastructure?()
What will improve the battery life of a Cisco Unified Wireless IP Phone 7921G?()
Which keypad sequence will reset the Cisco Unified Wireless IP Phone 7921 to factory default?()
Which two multicast modes are valid options for use with Ethernet bridging on a mesh AP?()