A.minimum jitter
B.maximum jitter
C.upstream standard packet deviation
D.average MOS value
E.average conceal rate
您可能感興趣的試卷
你可能感興趣的試題
A.The phone does a directed call hangup on 802.11b,then does an auto-redial on 802.11a,creating a new call.
B.The phone does a directed call hangup on 802.11b, then the user does a redial on 802.11a,creating a new call.
C.The phone does a disassociation on 802.11b and an association on 802.11a,and call remains up if the subnet has not changed.
D.The phone does not roam from 802.11b to 802.11a when on an active call.
E.The phone must switch network profiles to roam from 802.11b to 802.11a.
A.RSSI of the client at the access point
B.WMM state
C.current MOS value
D.current RF channel
E.current transmit data rate
A.disable higher data rates
B.set DTIM = 1
C.disable RRM
D.disable broadcast SSID
E.disable multicast
A.duplicate sender packets
B.unicast packet retry rate
C.unicast packet retry ratio
D.association rejections
A.user request using the keypad of the phone and HTTP download
B.IT department scheduled upgrade using HTTP download
C.TFTP download based on version control through Cisco Unified Communications Manager
D.FTP download based on version control through Cisco Unified Communications Manager
E.HTTP download based on version control through Cisco Unified Communications Manager
A.Layer 3 with Layer 3 Security set to None and Web Policy set to Authentication
B.Layer 3 with Layer 3 Security set to None and Web Policy set to VPN Pass-Through
C.Layer 3 with Layer 3 Security set to VPN Pass-Through
D.Layer 2 with Layer 2 Security set to 802.1X
A.Yes,by modifying the LWAPP frame header DSCP value in transit.
B.Yes,by modifying the LWAPP frame header 802.1p value in transit.
C.No,the WMM queue classification parameter is transported inside the LWAPP tunnel.
D.No,the WMM queue classification parameter is determined at the AP based on the original client IP header DSCP value.
A.Voice traffic should be marked to DSCP EF per the QoS baseline and RFC3246.
B.Voice traffic loss should be no more than 3%.
C.One-way latency (mouth-to-ear) should be less than 150 msec.
D.Average one way jitter should be targeted to less than 30 msec.
E.21-320 Kbps of guaranteed priority bandwidth is required per call depending on sample rate,codec,and layer 2 overhead.
A.audit VoWLAN cell edge coverage
B.verify RFID tag coverage by four access points at -75 dBm
C.audit microwave oven interference
D.audit 802.11a channel 36 utilization
E.create test scripts for 802.11n bonded channel throughput tests
A.802.11e
B.802.11k
C.802.11i
D.802.11h
最新試題
Which three call information items does AirMagnet VoFi Analyzer provide? ()
Which three solutions does AirMagnet VoFi Pro Analyzer integrate?()
Which keypad sequence will reset the Cisco Unified Wireless IP Phone 7921 to factory default?()
Which statement describes the WLCv5.2 delivery of a multicast packet from a wired PC source on VLAN_X to a respective wireless client using SSID_X, using a WLAN controller enabled for multicast?()
What will improve the battery life of a Cisco Unified Wireless IP Phone 7921G?()
For which WMM queue is U-APSD most beneficial?()
Which statement is correct for both the LWAPP and CAPWAP AP upstream 802.1Q tagged wired QoS priority for a WMM-associated client frame that is H-REAP locally switched running v5.2?()
Which two EAP types does the Cisco Unified Wireless IP Phone 7921G firmware code version 1.3(x) support?()
An LWAPP encapsulated packet is being sent from the Cisco WLC v5.2 to the AP for a wireless WMM client. Can the LWAPP frame be altered to change the resulting final WMM queue for transmission on an 802.11 client?()
Which statement describes the call behavior of the Cisco Unified Wireless IP Phone 7921G when it roams from 802.11b to 802.11a?()