A.Yes，by modifying the LWAPP frame header DSCP value in transit.
B.Yes，by modifying the LWAPP frame header 802.1p value in transit.
C.No，the WMM queue classification parameter is transported inside the LWAPP tunnel.
D.No，the WMM queue classification parameter is determined at the AP based on the original client IP  header DSCP value.

A.Voice traffic should be marked to DSCP EF per the QoS baseline and RFC3246.
B.Voice traffic loss should be no more than 3%.
C.One-way latency （mouth-to-ear） should be less than 150 msec.
D.Average one way jitter should be targeted to less than 30 msec.
E.21-320 Kbps of guaranteed priority bandwidth is required per call depending on sample rate，codec，and  layer 2 overhead.

A.audit VoWLAN cell edge coverage
B.verify RFID tag coverage by four access points at -75 dBm
C.audit microwave oven interference
D.audit 802.11a channel 36 utilization
E.create test scripts for 802.11n bonded channel throughput tests

A.802.11e
B.802.11k
C.802.11i
D.802.11h

A.passed by the AP to its connected switch and then forwarded directly to the connected router，which  creates an MGID table entry
B.passed by the AP to the WLAN controller and then forwarded to the source PIM-enabled router，which  creates an MGID table entry
C.passed by the AP to the WLAN controller， which creates an MGID table entry before forwarding to the  directly connected PIM-enabled router
D.passed by the AP to its connected switch and then forwarded to the rendezvous point router，which  creates an MGID table entry

A.to determine if there are more clients that are using the multicast stream
B.to limit the time that a client has to request an IGMP join to the controller multicast group
C.to determine if the multicast router is still alive and responding to multicast clients
D.to remove clients from the multicast group if the multicast traffic exceeds the allotted bandwidth allowed  for multicast clients

A.TSPEC IE
B.TSRS IE
C.WMM IE
D.TSM IE

A.Wireless client WMM UP classification is translated to a wired DSCP priority.
B.Wireless client 802.11p classification is translated to a wired DSCP priority.
C.Wireless client WMM UP classification is translated to a wired 802.1p CoS priority.
D.Wireless client 802.11p classification is translated to a wired 802.1p CoS priority.

A.Packet loss is less than one percent.
B.Signal strength at cell edge is approximately -67 dBm.
C.End-to-end delay is less than 200 ms.
D.Cell overlap between APs is 50 percent.

A.the codec used by the calling phone
B.approximate length of the call in minutes
C.MOS values throughout the duration of the call
D.802.11e access category overruns
E.co-channel interference percentage during the call