A.Packet loss is less than one percent.
B.Signal strength at cell edge is approximately -67 dBm.
C.End-to-end delay is less than 200 ms.
D.Cell overlap between APs is 50 percent.
您可能感興趣的試卷
你可能感興趣的試題
A.the codec used by the calling phone
B.approximate length of the call in minutes
C.MOS values throughout the duration of the call
D.802.11e access category overruns
E.co-channel interference percentage during the call
A.Client issues an IGMP join after association with AP2, allowing AP2 to request a multicast stream from Cisco WLC after AP1 issues an IGMP query.
B.Client issues an IGMP join after association with AP2, allowing AP2 to request a multicast stream from Cisco WLC independent of AP1 multicast member status.
C.Client resumes multicast after association with AP2, because multicast information is sent in mobility exchanges and AP2 is already a member of the multicast group, provided that another client has already joined that multicast.
D.Client resumes multicast after association with AP2, because multicast information is sent in mobility exchanges and AP2 is already a member of the multicast group, regardless if any other clients have already joined that multicast.
A.DTIM
B.Ethernet multicast mode
C.peer-to-peer block mode
D.RF group mode
E.DTPC
A.EAP-TLS
B.EAP-PEAP
C.EAP-LEAP
D.EAP-TTLS
A.globally scoped address range
B.239.0.0.X or 239.128.0.X address range
C.administratively scoped address range that does not overlap with a link-local MAC address
D.any Class D address range
E.site-local scoped address range
A.Avoid channels with microwave oven noise.
B.Manually remove channels not supported by the VoWLAN clients.
C.Avoid 802.11n 40-MHz wide channels.
D.Automatically avoid nearby radar.
A.Wireless client WMM UP classification is translated to a wired DSCP priority.
B.Wireless client 802.11p classification is translated to a wired DSCP priority.
C.Wireless client WMM UP classification is translated to a wired 802.1p CoS priority.
D.Wireless client 802.11p classification is translated to a wired 802.1p CoS priority.
E.WLAN configured QoS level is used to set the wired DSCP priority.
F.Wired 802.1p CoS priority is not set.
A.A packet is delivered to Cisco WLC and forwarded via multicast to all of its associated APs, and finally to all wireless clients of that Cisco WLC, via wireless multicast.
B.A packet is delivered to Cisco WLC and forwarded via unicast to all of its associated APs, and finally to all wireless clients of that Cisco WLC, via wireless unicast.
C.A packet is delivered to Cisco WLC and forwarded via multicast to all of its associated APs, discarded at APs without SSID_X joined wireless clients, and forwarded at APs with SSID_X joinedwireless clients via wireless multicast.
D.A packet is delivered to Cisco WLC and forwarded via unicast to all of its associated APs, discarded at APs without SSID_X joined wireless clients, and forwarded at APs with SSID_X joined wireless clients via wireless multicast.
E.A packet is delivered to Cisco WLC and forwarded via multicast to all of its associated APs, discarded at APs without SSID_X joined wireless clients, and forwarded at APs with SSID_X joinedwireless clients via wireless unicast.
F.A packet is delivered to Cisco WLC and forwarded via unicast to all of its associated APs, discarded at APs without SSID_X joined wireless clients, and forwarded at APs with SSID_X joined wireless clients via wireless unicast.
A.UP
B.VO
C.VI
D.BK
E.BE
A.must be Cisco Compatible Extensions version 2
B.must be Cisco Compatible Extensions version 3
C.must be Cisco Compatible Extensions version 4
D.must be associated to a Platinum QoS WLAN
E.must be associated to an access point on a Cisco WLC with code version 5.0 or newer
最新試題
How do Cisco Unified Communications IP phones receive firmware upgrades?()
Which statement describes the call behavior of the Cisco Unified Wireless IP Phone 7921G when it roams from 802.11b to 802.11a?()
Which statement describes the WLCv5.2 delivery of a multicast packet from a wired PC source on VLAN_X to a respective wireless client using SSID_X, using a WLAN controller enabled for multicast?()
For which WMM queue is U-APSD most beneficial?()
When designing the coverage area for high call capacity, what two actions should be done with data rates and channels?()
An LWAPP encapsulated packet is being sent from the Cisco WLC v5.2 to the AP for a wireless WMM client. Can the LWAPP frame be altered to change the resulting final WMM queue for transmission on an 802.11 client?()
What is the WMM user priority of the packets going downstream to the client when the client does not support TSPEC but the Cisco WLC has ACM enabled and WLAN priority is set to Platinum?()
Which three are benefits of U-APSD?()
What is the bandwidth requirement of an active duplex wireless call using G.711 codec?()
What is the Cisco recommended setting for the Cisco Unified Wireless Network WLC Voice Call Admission Control Max RF Bandwidth to support the Cisco Unified Wireless IP Phone 7921G?()