A.passed by the AP to its connected switch and then forwarded directly to the connected router,which creates an MGID table entry
B.passed by the AP to the WLAN controller and then forwarded to the source PIM-enabled router,which creates an MGID table entry
C.passed by the AP to the WLAN controller, which creates an MGID table entry before forwarding to the directly connected PIM-enabled router
D.passed by the AP to its connected switch and then forwarded to the rendezvous point router,which creates an MGID table entry
您可能感興趣的試卷
你可能感興趣的試題
A.to determine if there are more clients that are using the multicast stream
B.to limit the time that a client has to request an IGMP join to the controller multicast group
C.to determine if the multicast router is still alive and responding to multicast clients
D.to remove clients from the multicast group if the multicast traffic exceeds the allotted bandwidth allowed for multicast clients
A.TSPEC IE
B.TSRS IE
C.WMM IE
D.TSM IE
A.Wireless client WMM UP classification is translated to a wired DSCP priority.
B.Wireless client 802.11p classification is translated to a wired DSCP priority.
C.Wireless client WMM UP classification is translated to a wired 802.1p CoS priority.
D.Wireless client 802.11p classification is translated to a wired 802.1p CoS priority.
A.Packet loss is less than one percent.
B.Signal strength at cell edge is approximately -67 dBm.
C.End-to-end delay is less than 200 ms.
D.Cell overlap between APs is 50 percent.
A.the codec used by the calling phone
B.approximate length of the call in minutes
C.MOS values throughout the duration of the call
D.802.11e access category overruns
E.co-channel interference percentage during the call
A.Client issues an IGMP join after association with AP2, allowing AP2 to request a multicast stream from Cisco WLC after AP1 issues an IGMP query.
B.Client issues an IGMP join after association with AP2, allowing AP2 to request a multicast stream from Cisco WLC independent of AP1 multicast member status.
C.Client resumes multicast after association with AP2, because multicast information is sent in mobility exchanges and AP2 is already a member of the multicast group, provided that another client has already joined that multicast.
D.Client resumes multicast after association with AP2, because multicast information is sent in mobility exchanges and AP2 is already a member of the multicast group, regardless if any other clients have already joined that multicast.
A.DTIM
B.Ethernet multicast mode
C.peer-to-peer block mode
D.RF group mode
E.DTPC
A.EAP-TLS
B.EAP-PEAP
C.EAP-LEAP
D.EAP-TTLS
A.globally scoped address range
B.239.0.0.X or 239.128.0.X address range
C.administratively scoped address range that does not overlap with a link-local MAC address
D.any Class D address range
E.site-local scoped address range
A.Avoid channels with microwave oven noise.
B.Manually remove channels not supported by the VoWLAN clients.
C.Avoid 802.11n 40-MHz wide channels.
D.Automatically avoid nearby radar.
最新試題
What is the minimum configuration you must do in order to enable multicast support on the CiscoWireless LAN Controller v5.2?()
What is the bandwidth requirement of an active duplex wireless call using G.711 codec?()
Which three are interframe spaces defined in 802.11?()
Which two multicast modes are valid options for use with Ethernet bridging on a mesh AP?()
Which configuration is required for a Vocera badge to function properly on a Cisco WLC?()
Which three solutions does AirMagnet VoFi Pro Analyzer integrate?()
Which statement describes the WLCv5.2 delivery of a multicast packet from a wired PC source on VLAN_X to a respective wireless client using SSID_X, using a WLAN controller enabled for multicast?()
An LWAPP encapsulated packet is being sent from the Cisco WLC v5.2 to the AP for a wireless WMM client. Can the LWAPP frame be altered to change the resulting final WMM queue for transmission on an 802.11 client?()
What is the recommended minimum speed at the edge of the cells in an 802.11g network for a good Cisco VoWLAN deployment?()
For which quality of service parameter should the WLAN for VoWLAN clients be configured?()