單項選擇題There are six phases of the Cisco Network Lifecycle Services framework. What are they?()

A. Prepare, Plan, Design, Apply, Operate, and Manage
B. Prepare, Plan, Design, Implement, Operate, and Optimize
C. Prepare, Plan, Design, Implement, Operate and Manage
D. Prepare, Plan, Create, Implement, Operate, and Improve


您可能感興趣的試卷

你可能感興趣的試題

4.單項選擇題Which of the following command allows you to view the UDI information for a Cisco device?()

A. show environment
B. show status
C. show inventory
D. show hardware

5.多項選擇題What are three pieces of information that the Cisco IOS show inventory command displays on a Cisco ISR Router? ()(Choose three.)

A. Installed Hardware serial numbers
B. The status of installed hardware
C. Installed hardware
D. Unique Device Identifier
E. system internal temperature
F. main power supply condition

6.單項選擇題What is required to enable fragmentation of large FTP packets when voice quality on the network is affected by FTP transfers?()

A. Configure TCP header compression on interface
B. Configure MPL on the Frame Relay interfaces
C. Configure FRF 12 fragmentation on the Frame Relay interfaces
D. Fragmentation is not supported with service internetworking

10.多項選擇題

Refer to the exhibit. Which two of these accurately describe this router's supervisor redundancy status? ()(Choose two.)

A. both supervisors are active
B. SSO redundancy is being used
C. the second supervisor is unavailable
D. the primary supervisor is unavailable
E. the primary supervisor was reloaded nine seconds ago

最新試題

Refer to the exhibit. You want to minimize the downtime that results from supervisor engine switchovers on Cisco 6500 Series Switches and Cisco 7600 Series Routers. To achieve this, you are considering deploying a Cisco Nonstop Forwarding with Stateful Switchover solution using OSPF.In the exhibit you can see the output of the show ip ospf neighbor detail command.Which trait of systems using Cisco Nonstop Forwarding with Stateful Switchover and OSPF is shown in the exhibit output and will impact your plan?()

題型:單項選擇題

You are trying to initiate an SSH connection to a remote router and are getting rejected with an error code of 0. Which of these might be the cause of the error?()

題型:單項選擇題

What are four advantages to using tunnel brokers in an IPv6 transition environment?()

題型:多項選擇題

Refer to the exhibit. For the given configuration, on packets leaving the router on interface FastEthernet0/0 that matches the high traffic class, what will the MPLS experimental bit be set to?()

題型:單項選擇題

As an experienced network engineer, you are asked to troubleshoot a CIS network outage. During the troubleshooting process, you notice that one of your colleagues connects additional devices to the network with the use of his own switch. With the purpose of improving speed, the switch is attached to both network ports in an office, which leads to bridge loop.Enabling which of the following feature will be able to prevent this problem from happening again?()

題型:單項選擇題

In a RSTP implementation, which of the following two link types are used? ()(Choose two.)

題型:多項選擇題

What is the most likely reason that an IBGP route that has been selected as a best route is not entered into the IP routing table?()

題型:單項選擇題

On the Catalyst 6500 Series switch, which command is used to establish a console connection to the Firewall Services Module?()

題型:單項選擇題

Which three of these items are IPv6 transition mechanisms? ()(Choose three.)

題型:多項選擇題

Referring to the partial Cisco Catalyst switch configuration shown, which two of these statements are correct? ()(Choose two.)

題型:多項選擇題