A. Installed Hardware serial numbers
B. The status of installed hardware
C. Installed hardware
D. Unique Device Identifier
E. system internal temperature
F. main power supply condition
您可能感興趣的試卷
你可能感興趣的試題
A. Configure TCP header compression on interface
B. Configure MPL on the Frame Relay interfaces
C. Configure FRF 12 fragmentation on the Frame Relay interfaces
D. Fragmentation is not supported with service internetworking
The following exhibit displays the NetFlow statistics for a CIS router, which will be helpful for a network administrator to collect IP traffic information.
Which two numbers separately refer to the percentage of packets sized between 32 and 64 bytes and the number of flows in progress?（）
A. 24.9%, 980
B. 6.94%, 980
C. 69.4%, 35
D. cannot be determined from this output
E. 69.4%, 4061
You work as a network administrator in your company. Communication inside the company is ensured by network environments, such as GET VPN, Dynamic Multipoint VPN and Ethernet.
Which PIN architecture is applicable in those environments?（）
A.Campus
B.Teleworker
C.Branch
D.Data center
A. Branch
B. Campus
C. Teleworker
D. Data center
Refer to the exhibit. Which two of these accurately describe this router's supervisor redundancy status? （）(Choose two.)
A. both supervisors are active
B. SSO redundancy is being used
C. the second supervisor is unavailable
D. the primary supervisor is unavailable
E. the primary supervisor was reloaded nine seconds ago
Refer to the exhibit. What is the HSRP state and priority of this interface after HSRP reaches its steady state?（）
A. Active, Priority 151
B. Active, Priority 201
C. Active, Priority 251
D. Standby, Priority 151
E. Standby, Priority 201
F. Standby, Priority 251
HSRP. Known as Hot Stanclby Router Protocol, is a Cisco proprietarv redundancy protocol . As an experienced network administrator, you are required to configure HSRP on a XYZ network.
Which TWO of the following wii be available and shared between the routers configured with HSRP? （）(Choose two.)
A. a shared single interface
B. the ability to track serial interfaces
C. UDP-based hello packets
D. the impact of flapping links if timers are too low
A. It is achieved by using more than one HSRP group.
B. It is done in regards to either round robin or weight basis.
C. It is used to offload the active router in a certain HSRP group.
D. The return traffic is influenced by HSRP load sharing configuration.
E. Single group HSRP is used to achieve more efficient link utilization.
A.0000.5E00.010a
B.0000.0c07.ac0a
C.0000.0c07.0110
D.000.0cac.070a
A. Proxy ARP
B. IRDP
C. Dynamic Routing Protocol
D. VRRP
最新試題
Which of the following allows network administrators to easily apply common services and employ features across Cisco switches, routers, and access points with an intuitive GUI?（）
In a high-availability network, which command, when placed on ports that have connected end stations, will allow you to prevent delays in service for end stations by placing a port in blocking mode?（）
What is the most likely reason that an IBGP route that has been selected as a best route is not entered into the IP routing table?（）
Which command displays only those entries in a BGP table with specific AS_PATH attributes?（）
Refer to the exhibit. You want to minimize the downtime that results from supervisor engine switchovers on Cisco 6500 Series Switches and Cisco 7600 Series Routers. To achieve this, you are considering deploying a Cisco Nonstop Forwarding with Stateful Switchover solution using OSPF.In the exhibit you can see the output of the show ip ospf neighbor detail command.Which trait of systems using Cisco Nonstop Forwarding with Stateful Switchover and OSPF is shown in the exhibit output and will impact your plan?（）
What is the function of the no switchport catalyst switch interface configuration command?（）
Refer to the exhibit. For the given configuration, on packets leaving the router on interface FastEthernet0/0 that matches the high traffic class, what will the MPLS experimental bit be set to?（）
What is the maximum number of Cisco Catalyst 3750 Series Switches that can be united into a single manageable unit using the Cisco StackWise technology?（）
Refer to the exhibit. Which two of these statements are correct? (Choose two.)（）
Refer to the exhibit. Which SSH sessions will the SSH server accept?（）