The following exhibit displays the NetFlow statistics for a CIS router, which will be helpful for a network administrator to collect IP traffic information.
Which two numbers separately refer to the percentage of packets sized between 32 and 64 bytes and the number of flows in progress?（）
A. 24.9%, 980
B. 6.94%, 980
C. 69.4%, 35
D. cannot be determined from this output
E. 69.4%, 4061
您可能感興趣的試卷
你可能感興趣的試題
You work as a network administrator in your company. Communication inside the company is ensured by network environments, such as GET VPN, Dynamic Multipoint VPN and Ethernet.
Which PIN architecture is applicable in those environments?（）
A.Campus
B.Teleworker
C.Branch
D.Data center
A. Branch
B. Campus
C. Teleworker
D. Data center
Refer to the exhibit. Which two of these accurately describe this router's supervisor redundancy status? （）(Choose two.)
A. both supervisors are active
B. SSO redundancy is being used
C. the second supervisor is unavailable
D. the primary supervisor is unavailable
E. the primary supervisor was reloaded nine seconds ago
Refer to the exhibit. What is the HSRP state and priority of this interface after HSRP reaches its steady state?（）
A. Active, Priority 151
B. Active, Priority 201
C. Active, Priority 251
D. Standby, Priority 151
E. Standby, Priority 201
F. Standby, Priority 251
HSRP. Known as Hot Stanclby Router Protocol, is a Cisco proprietarv redundancy protocol . As an experienced network administrator, you are required to configure HSRP on a XYZ network.
Which TWO of the following wii be available and shared between the routers configured with HSRP? （）(Choose two.)
A. a shared single interface
B. the ability to track serial interfaces
C. UDP-based hello packets
D. the impact of flapping links if timers are too low
A. It is achieved by using more than one HSRP group.
B. It is done in regards to either round robin or weight basis.
C. It is used to offload the active router in a certain HSRP group.
D. The return traffic is influenced by HSRP load sharing configuration.
E. Single group HSRP is used to achieve more efficient link utilization.
A.0000.5E00.010a
B.0000.0c07.ac0a
C.0000.0c07.0110
D.000.0cac.070a
A. Proxy ARP
B. IRDP
C. Dynamic Routing Protocol
D. VRRP
A.Both Gateway Load Balancing Protocoland Hot Stand by Router Protocol
B.Gateway Load Balancing Protocol
C.Virtual Router Redundancy Protocol
D.Hot Stand by Router Protocol
A. Shared single interface
B. IP Address
C. TCP-based hello packets
D. MAC address
最新試題
As an experienced network engineer, you are asked to troubleshoot a CIS network outage. During the troubleshooting process, you notice that one of your colleagues connects additional devices to the network with the use of his own switch. With the purpose of improving speed, the switch is attached to both network ports in an office, which leads to bridge loop.Enabling which of the following feature will be able to prevent this problem from happening again?（）
Which Cisco IOS command is used to troubleshoot a problem in which a BGP session stays in the active state?（）
As a network administrator, you issue the interface auto qos voip cisco-phone command on a port in an edge network. It is possible for a Cisco Catalyst switch to check if a Cisco IP Phone is directly attached to that port by:（）
Which command is used to view IPv6 parameters related to the BGP process?（）
Refer to the exhibit. Which SSH sessions will the SSH server accept?（）
You are an experienced network administrator in an international corporation. One of your clients asks you to configure a network for a financial trading center which requires multiple high-value transactions.And the transactions are very important to the client. In such a situation, which two of the following are basic and most important requirements concerning the configuration? （）(Choose two.)
What is the function of the no switchport catalyst switch interface configuration command?（）
Referring to the partial Cisco Catalyst switch configuration shown, which two of these statements are correct? （）(Choose two.)
Refer to the exhibit. Which two of these events will be the result of issuing the above command? （）(Choose two.)
In a high-availability network, which command, when placed on ports that have connected end stations, will allow you to prevent delays in service for end stations by placing a port in blocking mode?（）