You work as a network administrator in your company. Communication inside the company is ensured by network environments, such as GET VPN, Dynamic Multipoint VPN and Ethernet.
Which PIN architecture is applicable in those environments?()
A.Campus
B.Teleworker
C.Branch
D.Data center
您可能感興趣的試卷
你可能感興趣的試題
A. Branch
B. Campus
C. Teleworker
D. Data center
Refer to the exhibit. Which two of these accurately describe this router's supervisor redundancy status? ()(Choose two.)
A. both supervisors are active
B. SSO redundancy is being used
C. the second supervisor is unavailable
D. the primary supervisor is unavailable
E. the primary supervisor was reloaded nine seconds ago
Refer to the exhibit. What is the HSRP state and priority of this interface after HSRP reaches its steady state?()
A. Active, Priority 151
B. Active, Priority 201
C. Active, Priority 251
D. Standby, Priority 151
E. Standby, Priority 201
F. Standby, Priority 251
HSRP. Known as Hot Stanclby Router Protocol, is a Cisco proprietarv redundancy protocol . As an experienced network administrator, you are required to configure HSRP on a XYZ network.
Which TWO of the following wii be available and shared between the routers configured with HSRP? ()(Choose two.)
A. a shared single interface
B. the ability to track serial interfaces
C. UDP-based hello packets
D. the impact of flapping links if timers are too low
A. It is achieved by using more than one HSRP group.
B. It is done in regards to either round robin or weight basis.
C. It is used to offload the active router in a certain HSRP group.
D. The return traffic is influenced by HSRP load sharing configuration.
E. Single group HSRP is used to achieve more efficient link utilization.
A.0000.5E00.010a
B.0000.0c07.ac0a
C.0000.0c07.0110
D.000.0cac.070a
A. Proxy ARP
B. IRDP
C. Dynamic Routing Protocol
D. VRRP
A.Both Gateway Load Balancing Protocoland Hot Stand by Router Protocol
B.Gateway Load Balancing Protocol
C.Virtual Router Redundancy Protocol
D.Hot Stand by Router Protocol
A. Shared single interface
B. IP Address
C. TCP-based hello packets
D. MAC address
A. It provides reliable input for verifying network consistency.
B. It requires a network audit to support some upgrade decisions.
C. It requires a network audit to support any network restructuring.
D. It begins with gathering organizational input that may be inaccurate.
最新試題
Which of the following is an easy-to-use tool that allows you to easily configure and monitor Cisco Integrated Services Routers?()
Referring to the partial Cisco Catalyst switch configuration shown, which two of these statements are correct? ()(Choose two.)
In a RSTP implementation, which of the following two link types are used? ()(Choose two.)
What is the purpose of using VPN hardware acceleration equipment?()
What is the most likely reason that an IBGP route that has been selected as a best route is not entered into the IP routing table?()
Which command is used to view IPv6 parameters related to the BGP process?()
On the Catalyst 6500 Series switch, which command is used to establish a console connection to the Firewall Services Module?()
Refer to the exhibit. Which two of these statements are correct? (Choose two.)()
Which Cisco IOS command is used to troubleshoot a problem in which a BGP session stays in the active state?()
Refer to the exhibit. You want to minimize the downtime that results from supervisor engine switchovers on Cisco 6500 Series Switches and Cisco 7600 Series Routers. To achieve this, you are considering deploying a Cisco Nonstop Forwarding with Stateful Switchover solution using OSPF.In the exhibit you can see the output of the show ip ospf neighbor detail command.Which trait of systems using Cisco Nonstop Forwarding with Stateful Switchover and OSPF is shown in the exhibit output and will impact your plan?()