Scalability: with the cisco wireless location appliance, 2500 devices including wireless clients or wi-fi tags can be tracked simultaneously, helping ensure that location services can be applied to an entire enterprise environment.
Which of the following functions on the wireless lan controller is used to determine whether or not a rogue access point is connected to the same layer 2 network?()
A.rogue detector
B.rogue containment
C.rldp
D.ridp
您可能感興趣的試卷
你可能感興趣的試題
A.1000
B.2000
C.2500
D.1500
You are troubleshooting a problem with a cisco 7920 wireless ip phone on a standalone wlan. the phone rings but, when you Answer ,the call is dropped.
What may have caused this problem?()
A.publicly secure packet forwarding is enabled.
B.the minimum data rate is not set to 11 mbps.
C.an address resolution protocol is enabled.
D.the access point is set to the least congested channel.
A cisco wcs version 4.0 has been installed on a server with a dual pentium 3.0 ghz processor,4 gb ram,and an 80 gb hard drive. a location appliance has been incorporated into the network and is being monitored by the cisco wcs. there are 3000 devices to be tracked but not all of them are being tracked on the cisco wcs.
What can be done to correct the problem?()
A.add a new location appliance.
B.add a new cisco wcs server dedicated to the location appliance.
C.add 4 gb of ram to the cisco wcs.
D.add a 120 gb hard drive to the cisco wcs.
You are troubleshooting a problem with a cisco 7920 wireless ip phone that is causing the phone to drop calls. the problem appears to be a roaming bandwidth issuE. in order to verify what kind of issue it is, you decide to increase the bandwidth reserved for roaming on the wlan controller to the maximum.
What level do you set the bandwidth to?()
A.25 percent
B.15 percent
C.5 percent
D.35 percent
Using the wlse, you are trying to push out a configuration job to a standalone access point, but the job does not start.
Which of the following would cause this failure?()
A.invalid parameter in the template
B.incorrect snmp communities on the access point
C.pop-up blocker enabled in the browser
D.unsupported version of ios firmware in the access point
A.1000
B.1500
C.2000
D.2500
A.16 feet [4.8 meters]
B.24 feet [7.3 meters]
C.8 feet [2.4 meters]
D.40 feet [12.1 meters]
A.12 percent
B.6 percent
C.18 percent
D.24 percent
A.128
B.32
C.16
D.64
A.50
B.128
C.512
D.1024
最新試題
On a Cisco Aironet 802.11 a/b/g wireless LAN client adapter,the status LED and activity LED are alternating on and off.What does this indicate?()
Which protocol does the RADIUS server use inside the secure tunnel of EAP-FAST to authenticatethe client when one-time passwords are in use?()
A client roams from H-REAP AP1 to H-REAP AP2. The client is unable to associate to H-REAP AP2.H-REAP AP2 has six other clients associated to it, which continue to pass traffic.What has causedthis problem?()
Which of the following parameter sets must be configured on the Cisco Wireless Location Appliance?()
Which of the following commands on the wireless interface of a Cisco 3845 Integrated Service Router allows the SSID to broadcast?()
The IOS of a North American Cisco Aironet 1130AG Series standalone access point has becomecorrupt. You must therefore reload the TFTP firmware.Before you press and hold the MODEbutton, you should verify that the file name is which of the following?()
When configuring a WLAN controller for a voice application using Cisco 7920 wireless IP phones,which two general control settings should you select?()
If it is properly deployed, a controller-based access point is capable of monitoring all VLANs on anetwork when you select which of the following modes from the AP Mode drop-down menu onthe controller?()
You are trying to change the polling parameters used by the location manager via the Cisco WCS,and your request is being denied. What is wrong?()
You are installing a Cisco 4402 Series Wireless LAN Controller.What type of interface is used on the uplink port?()