Using the wlse, you are trying to push out a configuration job to a standalone access point, but the job does not start.
Which of the following would cause this failure?()
A.invalid parameter in the template
B.incorrect snmp communities on the access point
C.pop-up blocker enabled in the browser
D.unsupported version of ios firmware in the access point
您可能感興趣的試卷
你可能感興趣的試題
A.1000
B.1500
C.2000
D.2500
A.16 feet [4.8 meters]
B.24 feet [7.3 meters]
C.8 feet [2.4 meters]
D.40 feet [12.1 meters]
A.12 percent
B.6 percent
C.18 percent
D.24 percent
A.128
B.32
C.16
D.64
A.50
B.128
C.512
D.1024
You are using adu and are authenticated and associated to an access point. however, you are unable to obtain an ip address.
Which of these has caused this problem?()
A.invalid ssid
B.invalid wep key
C.invalid encryption type
D.invalid 802.1x authentication type
A.network connections
B.location views
C.access points
D.object definitions
Yours truly, have been called upon to add location-based services into an existing controller-based wireless design which primarily encompasses handheld devices such as barcode scannersand cisco 7920 wireless ip phones.
In which mode should you deploy the additional access points to achieve the density required without excessive co-channel interference?()
A.tracking mode
B.monitor mode
C.location mode
D.sniffer mode
A cisco aironet 1020 controller-based access point has been connected to a catalyst 3550-24 pwr switch. however, when it is powered up, the access point fails.
What has caused this problem?()
A.access point does not support 802.11h
B.incorrect switch power supply
C.switch port is not enabled
D.switch does not support 802.3af
E.access point has not been initialized with the primary controller
最新試題
Which of the following commands on the wireless interface of a Cisco 3845 Integrated Service Router allows the SSID to broadcast?()
You have just finished aligning a Cisco Aironet 1400 Series Wireless Bridge link using installationmode. When you set the link back to operational mode you loose association to the root bridge.Which action will correct the problem?()
You are troubleshooting a one-way call problem with a Cisco 7920 wireless IP phone on a standalone WLAN.What may cause this problem?()
If it is properly deployed, a controller-based access point is capable of monitoring all VLANs on anetwork when you select which of the following modes from the AP Mode drop-down menu onthe controller?()
Static WEP is configured on the access point. You are authenticated and associated to the accesspoint but are unable to obtain an IP address.Which of the following will cause this problem?()
Which of the following parameter sets must be configured on the Cisco Wireless Location Appliance?()
You want to dynamically assign users to an 802.1Q VLAN as a result of their authentication. Inorder to accomplish this.Which two IETF RADIUS attributes should you configure on the CiscoSecure ACS? ()
How many WLANs can a Cisco Aironet 1242 in H-REAP mode support when actively connected toa wireless controller?()
On a Cisco Aironet 1240AG Series standalone access point, the radio LED is dark blue and blinking,but the status LED and Ethernet LED are both off.What does this indicate?()
You are installing a Cisco 4402 Series Wireless LAN Controller.What type of interface is used on the uplink port?()