您可能感興趣的試卷
你可能感興趣的試題
Refer to the exhibit. According to the output of the command show tag-switching forwarding-table, which four of these statements are true?（）
A.Packets to the IP address 10.10.10.5/32 will be tagged with "17" toward the next hop.
B.Label "19" will be advertised to MPLS neighbors so that they can use this label to reach the IP address 10.10.10.6/32.
C.IP address 10.10.10.4/32 is directly connected to the neighbor router on serial 3/0.
D.Packets arriving with label "17" will be forwarded without any label toward serial 4/0.
E.Packets arriving with label "20" will be forwarded with label "21" after label-swapping.
F.Label "20" is advertised to MPLS neighbors so that they can use this information to reach the prefix 10.10.10.8/32.
Refer to the exhibit. There are two sites connected across WAN links. All intersite and intrasite links always have the same routing metric. The network administrator sees only the top routers and links being used by hosts at both LAN A and LAN B. What would be two suggestions to load-balance the traffic across both WAN links?（）
A.Make HSRP track interfaces between the edge and core routers.
B.Replace HSRP with GLBP.
C.Add crossed intrasite links： R1-R4， R2-R3， R5-R8， and R6-R7.
D.Make R3 and R8 have lower HSRP priority than R1 and R7.
E.Replace HSRP with VRRP
A.ping 192.168.1.255
B.ping with sweep option
C.ping 192.168.1.127
D.ping 192.168.1.64
E.ping with broadcast option
A.OSPF standard hellos
B.Cisco Discovery Protocol link detection
C.Bidirectional Forwarding Detection
D.Fast Link Pulse
E.autonegotiation
Refer to the exhibit. R2 and R3 are routers connected using Ethernet services from a service provider and can receive pings from each other. OSPF is configured as the routing protocol but adjacency is not happening. According to the output of the show commands in the exhibit, what could be the most likely cause of the problem?（）
A.Ethernet interfaces were configured as point-to-point.
B.Process IDs are not matching.
C.Configured bandwidths do not match on both interfaces.
D.Broadcasts and multicast are not being propagated over the Ethernet services.
E.OSPF cost does not match on both interfaces.
最新試題
什么問題導致SERVER VTP密碼跟替他交換機VTP密碼不匹配？
兩ebgp鄰居發路由過來 ，哪些屬性重置？
QoS Mechanisms：?jiǎn)栐诓渴餛oS中要用的3個mechanisms是什么？
什么是NAT？
Refer to the exhibit.How many broadcast domains exist in theexhibited topology？（）
Refer to the exhibit.The network administrator is in acampus building distant from Building B.WANRouter is hosting a newly installed WAN link on interface S0/0.The new link is not functioning and the administrator needs to determine if the correct cable has been attached to the S0/0 interface.How can the administrator accurately verify the correct cable type on S0/0 in the most efficient manner?（）
The Frame Relay network in the diagram is not functioning properly.What is the cause of the problem?（）
A network administrator is troubleshooting the OSPF configuration of routers R1 and R2.The routers cannot establish an adjacency relationship on their common Ethernet link.The graphic shows the output of the show ip ospf interface e0 command for routers R1 and R2.Based on the information in the graphic,what is the cause of this problem?（）
The following configuration line was added to router R1 Access-list 101 permit ip 10.25.30.00.0.0.255 any What is the effect of this access list configuration?（）
如何實現擁塞避免？