多項選擇題

Refer to the exhibit. According to the output of the command show tag-switching forwarding-table, which four of these statements are true?()

A.Packets to the IP address 10.10.10.5/32 will be tagged with "17" toward the next hop.
B.Label "19" will be advertised to MPLS neighbors so that they can use this label to reach the IP address 10.10.10.6/32.
C.IP address 10.10.10.4/32 is directly connected to the neighbor router on serial 3/0.
D.Packets arriving with label "17" will be forwarded without any label toward serial 4/0.
E.Packets arriving with label "20" will be forwarded with label "21" after label-swapping.
F.Label "20" is advertised to MPLS neighbors so that they can use this information to reach the prefix 10.10.10.8/32.


您可能感興趣的試卷

你可能感興趣的試題

2.多項選擇題

Refer to the exhibit. There are two sites connected across WAN links. All intersite and intrasite links always have the same routing metric. The network administrator sees only the top routers and links being used by hosts at both LAN A and LAN B. What would be two suggestions to load-balance the traffic across both WAN links?()

A.Make HSRP track interfaces between the edge and core routers.
B.Replace HSRP with GLBP.
C.Add crossed intrasite links: R1-R4, R2-R3, R5-R8, and R6-R7.
D.Make R3 and R8 have lower HSRP priority than R1 and R7.
E.Replace HSRP with VRRP

5.單項選擇題Which mechanism can you use to achieve sub-second failover for link failure detection when a switched Ethernet media is used and loss of signal is not supported by the link provider?()

A.OSPF standard hellos
B.Cisco Discovery Protocol link detection
C.Bidirectional Forwarding Detection
D.Fast Link Pulse
E.autonegotiation

6.單項選擇題

Refer to the exhibit. R2 and R3 are routers connected using Ethernet services from a service provider and can receive pings from each other. OSPF is configured as the routing protocol but adjacency is not happening. According to the output of the show commands in the exhibit, what could be the most likely cause of the problem?()

A.Ethernet interfaces were configured as point-to-point.
B.Process IDs are not matching.
C.Configured bandwidths do not match on both interfaces.
D.Broadcasts and multicast are not being propagated over the Ethernet services.
E.OSPF cost does not match on both interfaces.

9.單項選擇題

Refer to the exhibit. You are setting up a 2-gigabit EtherChannel. Following IEEE standards, the exhibit shows your configuration in a local switch1. However, EtherChannel is not coming up. Which one of these statements could be a possible reason?()

A.EtherChannel is only available in Cisco equipment.
B.The customer side is supposed to be running PAgP, which is a Cisco standard.
C.PAgP is not an IEEE standard. VRRP should be used.
D.The configuration on switch1 needs to be modified to use LACP.