Refer to the exhibit. There are two sites connected across WAN links. All intersite and intrasite links always have the same routing metric. The network administrator sees only the top routers and links being used by hosts at both LAN A and LAN B. What would be two suggestions to load-balance the traffic across both WAN links?()
A.Make HSRP track interfaces between the edge and core routers.
B.Replace HSRP with GLBP.
C.Add crossed intrasite links: R1-R4, R2-R3, R5-R8, and R6-R7.
D.Make R3 and R8 have lower HSRP priority than R1 and R7.
E.Replace HSRP with VRRP
您可能感興趣的試卷
你可能感興趣的試題
A.ping 192.168.1.255
B.ping with sweep option
C.ping 192.168.1.127
D.ping 192.168.1.64
E.ping with broadcast option
A.OSPF standard hellos
B.Cisco Discovery Protocol link detection
C.Bidirectional Forwarding Detection
D.Fast Link Pulse
E.autonegotiation
Refer to the exhibit. R2 and R3 are routers connected using Ethernet services from a service provider and can receive pings from each other. OSPF is configured as the routing protocol but adjacency is not happening. According to the output of the show commands in the exhibit, what could be the most likely cause of the problem?()
A.Ethernet interfaces were configured as point-to-point.
B.Process IDs are not matching.
C.Configured bandwidths do not match on both interfaces.
D.Broadcasts and multicast are not being propagated over the Ethernet services.
E.OSPF cost does not match on both interfaces.
Refer to the exhibit. You are setting up a 2-gigabit EtherChannel. Following IEEE standards, the exhibit shows your configuration in a local switch1. However, EtherChannel is not coming up. Which one of these statements could be a possible reason?()
A.EtherChannel is only available in Cisco equipment.
B.The customer side is supposed to be running PAgP, which is a Cisco standard.
C.PAgP is not an IEEE standard. VRRP should be used.
D.The configuration on switch1 needs to be modified to use LACP.
A.RTP
B.RTSP
C.HTTP
D.TCP
E.UDP
A.75 percent
B.60 percent
C.56 percent
D.50 percent
E.25 percent
最新試題
What is the next state of initial in spanning-tree protocol?
A network administrator is troubleshooting the OSPF configuration of routers R1 and R2.The routers cannot establish an adjacency relationship on their common Ethernet link.The graphic shows the output of the show ip ospf interface e0 command for routers R1 and R2.Based on the information in the graphic,what is the cause of this problem?()
hsrp speak狀態是什么意思?
當將多個交換機加入到MST region當中會發生什么(what happen)?
什么問題導致SERVER VTP密碼跟替他交換機VTP密碼不匹配?
DHCP SERVER在給一個網段設置POOL時,該網段路由器接口地址能不能放入POOL,能why,不能why。
什么是NAT?
R1 will choose which path to reach 10.1.0.0?
aaa架構中哪個是要求用戶輸入用戶名和密碼?
如何實現擁塞避免?