問答題

三臺路由器，問：在路由器B（即中間的那臺路由器）上的E0/1的IN方向做一個(gè)ACL，要求路由器A可以TELNET路由器C，但是路由器C不可以TELNET路由器A。要求寫出ACL命令行。


您可能感興趣的試卷

你可能感興趣的試題

2.單項(xiàng)選擇題Which mechanism can you use to achieve sub-second failover for link failure detection when a switched Ethernet media is used and loss of signal is not supported by the link provider？（）

A.OSPF standard hellos
B.Cisco Discovery Protocol link detection
C.Bidirectional Forwarding Detection
D.Fast Link Pulse
E.autonegotiation

3.單項(xiàng)選擇題

Refer to the exhibit. R2 and R3 are routers connected using Ethernet services from a service provider and can receive pings from each other. OSPF is configured as the routing protocol but adjacency is not happening. According to the output of the show commands in the exhibit, what could be the most likely cause of the problem?（）

A.Ethernet interfaces were configured as point-to-point.
B.Process IDs are not matching.
C.Configured bandwidths do not match on both interfaces.
D.Broadcasts and multicast are not being propagated over the Ethernet services.
E.OSPF cost does not match on both interfaces.

6.單項(xiàng)選擇題

Refer to the exhibit. You are setting up a 2-gigabit EtherChannel. Following IEEE standards, the exhibit shows your configuration in a local switch1. However, EtherChannel is not coming up. Which one of these statements could be a possible reason?（）

A.EtherChannel is only available in Cisco equipment.
B.The customer side is supposed to be running PAgP， which is a Cisco standard.
C.PAgP is not an IEEE standard. VRRP should be used.
D.The configuration on switch1 needs to be modified to use LACP.