A.IGMPv3 has the ability to include or exclude source lists.
B.All IGMPv3 hosts send reports to destination address 224.0.0.22.
C.Only IGMPv2 reports may contain multiple group state records.
D.All IGMPv3 hosts send reports to destination address 224.0.0.23.
E.IGMPv2 does not support the Leave Group message.
您可能感興趣的試卷
你可能感興趣的試題
A.ip pim ssm
B.ip pim ssm 232.0.0.0 255.0.0.0
C.ip pim ssm range 50
D.access-list 50 permit 232.0.0.0 15.255.255.255
E.ip pim enable default
Based on the output provided in the exhibit, to which address or location will the router forward a packet sent to 192.168.32.1?()
A. 10.1.1.1
B. 10.1.1.2
C. 10.1.1.3
D. The default gateway
A.Source-Active Message
B.PIM Join
C.PIM Hello
D.MSDP Register
A.224.0.1.37
B.224.0.1.38
C.224.0.1.39
D.224.0.1.40
Based on the exhibit presented. What will be the objective of this route map when applied to traffic passing through a router?()
A. Take any packet sourced from any address in the 10.2.0.0/16 network or destined to 10.1.14.25 and set the next hop to 10.1.1.1
B. Take any packet sourced from any address in the 10.2.0.0/16 network and destined to 10.1.14.25 and set the next hop to 10.1.1.1
C. Nothing; extended access lists are not allowed in route maps used for policy-based routing
D. Drop any packet sourced from 10.2.0.0/16
A.Register
B.Register-Stop
C.Join/Prune
D.Reject
E.Register-Prune
F.Register-Join
A.router-id 1.2.3.4
B.router-id 2011::1
C.router-id Loopback0
D.router-id FF02::5
A.filter-list
B.inbound ACL
C.route-map
D.outbound ACL
E.prefix-list
F.neighbor 10.0.0.1 deny-map my-map command
A.configuring EIGRP stubs
B.configuring a second EIGRP AS and redistributing
C.configuring summary addresses
D.configuring an offset-list
E.configuring a prefix-list
F.configuring unicast neighbors
A.It will fragment the packet at Layer 2.
B.It will fragment the packet at Layer 3.
C.It will drop the packet and send an ICMPv6 message "packet too big" back to the source.
D.It will drop the packet.
最新試題
Which two EIGRP options will limit a query domain?()
Choose two commands that are required to enable multicast on a router, when it is known that thereceivers use a specific functionality of IGMPv3.()
Based on the exhibit presented. What will be the objective of this route map when applied to traffic passing through a router?()
An expanding company is deploying leased lines between its main site and two remote sites. Thebandwidth of the leased lines is 128kb/s each,terminated on different serial interfaces on the main router.These links are used for combined VOIP and data traffic. The network administrator has implemented a VOIP solution to reduce costs,and has therefore reserved sufficient bandwidth in a low latency queue oneach interface for the VOIP traffic. Users now complain about bad voice quality although no drops areobserved in the low latency queue. What action will likely fix this problem?()
The classic Spanning Tree Protocol (802.1 D 1998) uses which sequence of variables to determine thebest received BPDU?()
In order to configure two routers as anycast RPs, which of these requirements, af a minimum, must besatisfied?()
Which of these best describes the actions taken when a VTP message is received on a switch configuredwith the VTP mode "transparent"?()
Which of the following is true about the MPLS header and its EXP field size?()
All of these are fundamental building blocks of differentiated services Traffic Conditioner Block exceptwhich one?()
Which of these statements about penultimate hop popping are true?()