A.mark VOIP traffic with IP precedence 6 and configure only fair-queue’ on the links
B.configure the scheduler allocate 3000 1000 command to allow the OoS code to have enough CPU cycles
C.enable class-based traffic shaping on the VOIP traffic class
D.enable Layer 2 fragmentation and interleaving on the links
E.enable Frame Relay on the links and send voice and data on different Frame Relay PVCs
您可能感興趣的試卷
你可能感興趣的試題
A.1） lowest root bridge id，2） lowest sender bridge id，3） lowest port id，4） lowest root path cost
B.1） lowest root path cost，2） lowest root bridge id，3） lowest sender bridge id，4） lowest sender port id
C.1） lowest root bridge id，2） lowest sender bridge id，3） lowest root path cost，4） lowest sender port id
D.1） lowest root bridge id，2） lowest root path cost，3） lowest sender bridge id，4） lowest sender port id
A.VTP updates are ignored and forwarded out all ports.
B.VTP updates are ignored and forwarded out trunks only.
C.VTP updates are made to the VLAN database and are forwarded out trunks only.
D.VTP updates are ignored and are not forwarded.
A.8192
B.16384
C.49152
D.65535
A.Designated Root Cost
B.bridge ID priority
C.max age
D.bridge ID MAC address
E.Designated Root Priority
F.forward delay
A.one global STP instance for all VLANs
B.one STP instance for each VLAN
C.one STP instance per set of VLANs
D.one STP instance per set of bridges
A.Attempt to TELNET from the router connected to the inside of the firewall to the router connected to theoutside of the firewall. If telnet works， BGP will work， since telnet and BGP both use TCP to transportdata.
B.Ping from the router connected to the inside interface of the firewall to the router connected to theoutside interface of the firewall. If you can ping between them， BGP should work， since BGP uses IP totransport packets.
C.There is no way to make BGP work across a firewall without special configuration， so there is no simpletest that will show you if BGP will work or not， other than trying to start the peering session.
D.There is no way to make BGP work across a firewall.
A.ip pim rp-address
B.ip pim ssm
C.ip pim sparse-mode
D.ip pim passive
A.MD5
B.There is no Type 0 authentication
C.SHA1
D.Null
A.UDP/1812
B.UDP/1813
C.TCP/1812
D.TCP/1813
A.The MPLS header is 2 bytes，and the EXP field is 3 bits long.
B.The MPLS header is 1 byte，and the EXP field is 3 bits long.
C.The MPLS header is 4 bytes，and the EXP field is 3 bits long.
D.The MPLS header is 3 bytes，and the EXP field is 3 bits long.
最新試題
Spanning Tree Protocol IEEE 802.1 s defines the ability to deploy which of these？（）
Which three protocols or applications should be placed in a class that is configured with WRED？（）
Which three options are valid ways to filter routes from a BGP peer？（）
In Layer 2 topologies， spanning-tree failures can cause loops in the network. These unblocked loops cancause network failures because of excessive traffic. Which two Catalyst 6500 features can be used to limitexcessive traffic during spanning-tree loop conditions？（）
Two routers configured to run BGP have been connected to a firewall， one on the inside interface and one on the outside interface. BGP has been configured so the two routers should peer， including the correctBGP session endpoint addresses and the correct BGP session hop-count limit EBGP multihop. What is agood first test to see if BGP will work across the firewall？（）
On the basis of the network provided in the exhibit， all routers are configured to run EIGRP on all links. If the link between PG-R1 and PG-R2 fails， what is the maximum number of queries PG-R3 will receive for 192.168.1.0/24， assuming that all the packets sent during convergence are transmitted once （there are no dropped or retransmitted packets）？（）
Which of these best describes the actions taken when a VTP message is received on a switch configuredwith the VTP mode "transparent"？（）
Which of the following is true about the MPLS header and its EXP field size？（）
Which two statements about SA caching are true？（）
What is true about Unicast RPF in strict mode？（）