A.show ip pim rendez-vous
B.show ip rpf rp mapping
C.show ip pim rp mapping
D.show ip pim rp info
E.show ip pim
您可能感興趣的試卷
你可能感興趣的試題
A.it enables PIM BSR
B.it makes the router an Auto-RP mapping agent
C.it advertises the router as an RP with Auto-RP
D.it makes the router an Auto-RP client
A.It will send the join only to the neighbor with the highest IP address.
B.It will send the join only to the neighbor with the lowest IP address.
C.It will send the join in a round-robin fashion across all neighbors.
D.It will send the join to all neighbors.
A.2001：db8：3811：：1
B.2001：db8：3811：：2323
C.2001：db8：3811：：0130
D.2001：db8：3811：：3
E.2001：db8：3811：：6
A.Flooding paths and redundancy
B.Amount of routing information in the OSPF area or routing domain
C.Number of routers with Cisco Express Forwarding enabled
D.Number of neighbor adjacencies
E.Other routing protocols in use
F.OSPF timer reconstruction negotiation
G.Redistribution with BGP neighbors
H.Redistribution with other IGP routing protocols， such as RIP or EIGRP
A. BGP peers must be Layer 2-adjacent
B. EBGP multihop is not configured
C. The firewall is not configured to allow IP protocol 89
D. The firewall is not configured to allow UDP 179.
Refer to the exhibit. Users on the 199.155.24.0 network are unable to reach the 172.16.10.0 network. What is the most likely solution？（）
A. Router ISP1 should be configured to peer with router B
B. Router ISP2 should be configured with no synchronization
C. Router ISP1 should be configured with no synchronization
D. Router ISP2 should be configured with no auto-summary.
E. Router ISP1 or IPS2 should be configured with network 176.16.10.0 mask 255.255.255.0
A.It relies on IPv6 to do the fragmenting.
B.It splits the LS Update packet into smaller packets.
C.It splits the LSA into smaller router LSA packets.
D.It produces an error.
Refer to the exhibit. Routers A and B are directly connected and running OSPF， but they are unable to form a neighbor relationship. What is the most likely cause？（）
A. The routers are not on the same network.
B. The network statements do not match.
C. The process number does not match.
D. The MTU does not match.
E. The OSPF cost does not match.
F. There is a physical issue with the cable.
Refer to the exhibit. Routers A and B are directly connected and running EIGRP， but they are unable to form a neighbor relationship. What is the most likely cause？ （）
A. The network statements are misconfigured.
B. The IP address statements are misconfigured.
C. The autonomous system is misconfigured.
D. There is a physical issue with the cable.
Refer to the exhibit. Routers A and B are directly connected. Given the configuration， how many EIGRP routes will router B see in its routing table？（）
A. 0
B. 1
C. 2
D. 3
E. 4
最新試題
What is true about Unicast RPF in strict mode？（）
Which two are differences between IGMPv2 and IGMPv3 reports？（）
Which three options are valid ways to filter routes from a BGP peer？（）
Which message type is constructed and sent from an MSDP router to its MSDP peers when it receives a PIM register message knowing that the MSDP router is also configured as an RP for the PIM domain？（）
When STP UplinkFast is enabled on a switch utilizing the default bridge priority， what will the new bridgepriority be changed to？（）
An expanding company is deploying leased lines between its main site and two remote sites. Thebandwidth of the leased lines is 128kb/s each，terminated on different serial interfaces on the main router.These links are used for combined VOIP and data traffic. The network administrator has implemented a VOIP solution to reduce costs，and has therefore reserved sufficient bandwidth in a low latency queue oneach interface for the VOIP traffic. Users now complain about bad voice quality although no drops areobserved in the low latency queue. What action will likely fix this problem？（）
In order to configure two routers as anycast RPs， which of these requirements， af a minimum， must besatisfied？（）
Which command is used to enable SSM with the range 232.0.0.0 - 255.0.0.0？（）
The classic Spanning Tree Protocol （802.1 D 1998） uses which sequence of variables to determine thebest received BPDU？（）
Which three message types are valid PIMv2 message types？（）