A.Erase flash.
B.Restart the switch.
C.Delete the VLAN database.
D.Erase the running configuration.
E.Erase the startup configuration.
F.Modify the configuration register.

A.Microsegmentation decreases the number of collisions on the network.
B.if a switch receives a frame for an unkown destination，it uses ARP to resolve the address.
C.Spanning Tree Protocol allows switches to automatically share vlan information.
D.In a properly functioning network with redundant switched paths，each swiched aegment will contain oneroot bridge with all its ports in the forwarding state.All other switches in that broadcast domain will haveonly one root port.
E.Establishing vlans increases the number of  broadcast domains.
F.Switches that are configured with vlans make forwarding decisions based on both layer 2 and layer 3address information.

A.classful routing protocol
B.variable-length subnet masks
C.broadcast addressing
D.manual route summarization
E.uses SPF algorithm to compute path

A.ARP
B.CDP
C.DHCP
D.DNS
E.ICMP

A.The switch will ignore VTP summary advertisements.
B.The switch will forward VTP summary advertisements.
C.The switch will process VTP summary advertisements.
D.The switch will originate VTP summary advertisements.
E.The switch will create, modify and delete VLANs for the entire VTP domain.

A.A remote physical layer problem exists.
B.The host NIC is not functioning.
C.TCP/IP has not been correctly installed on the host.
D.A local physical layer problem exists.

A.10.188.31.0/27
B.10.188.31.0/26
C.10.188.31.0/29
D.10.188.31.0/28
E.10.188.31.0/25

A.24
B.4
C.3
D.16

A.VTP allows routing between VLANs.
B.VTP allows a single switch port to carry information to more than one VLAN.
C.VTP allows physically redundant links while preventing switching loops.
D.VTP simplifies switch administration by allowing switches to automatically share VLAN configuration information.
E.VTP helps to limit configuration errors by keeping VLAN naming consistent across the VTP domain.
F.VTP enhances security by preventing unauthorized hosts from connecting to the VTP domain.

A.Visually verify the MAC addresses and then telnet to the switches to enter the switchport-port security mac-address command.
B.Have end users e-mail their MAC addresses. Telnet to the switch to enter the switchport-port security mac-address command.
C.Use the switchport port-security MAC address sticky command on all the switch ports that have end devices connected to them.
D.Use show mac-address-table to determine the addresses that are associated with each port and then enter the commands on each switch for MAC address port-security.