A.The switch will ignore VTP summary advertisements.
B.The switch will forward VTP summary advertisements.
C.The switch will process VTP summary advertisements.
D.The switch will originate VTP summary advertisements.
E.The switch will create, modify and delete VLANs for the entire VTP domain.

A.A remote physical layer problem exists.
B.The host NIC is not functioning.
C.TCP/IP has not been correctly installed on the host.
D.A local physical layer problem exists.

A.10.188.31.0/27
B.10.188.31.0/26
C.10.188.31.0/29
D.10.188.31.0/28
E.10.188.31.0/25

A.24
B.4
C.3
D.16

A.VTP allows routing between VLANs.
B.VTP allows a single switch port to carry information to more than one VLAN.
C.VTP allows physically redundant links while preventing switching loops.
D.VTP simplifies switch administration by allowing switches to automatically share VLAN configuration information.
E.VTP helps to limit configuration errors by keeping VLAN naming consistent across the VTP domain.
F.VTP enhances security by preventing unauthorized hosts from connecting to the VTP domain.

A.Visually verify the MAC addresses and then telnet to the switches to enter the switchport-port security mac-address command.
B.Have end users e-mail their MAC addresses. Telnet to the switch to enter the switchport-port security mac-address command.
C.Use the switchport port-security MAC address sticky command on all the switch ports that have end devices connected to them.
D.Use show mac-address-table to determine the addresses that are associated with each port and then enter the commands on each switch for MAC address port-security.

A.Administratively shut down the interfaces.
B.Physically secure the interfaces.
C.Configure a virtual terminal password and login process.
D.Enter an access list and applyit to the terminal interfaces using theaccess-class command.
E.Create an access list and applyit to the terminal interfaces using theaccess-group command.

A.Configure the switch to be in VTP client mode.
B.Configure the switch to be in VTP domaint mode.
C.Configure the switch to be in VTP transparent mode.
D.Configure the switch to be in VTPv2

A.show interfaces interface
B.show interfaces interface trunk
C.show interfaces interface switchport
D.show ip interface brief
E.show interfaces vlan

A.Telnet to WANRouter and execute the command show interfaces S0/0
B.Telnet to WANRouter and execute the command show processes S0/0
C.Telnet to WANRouter and execute the command show running-configuration
D.Telnet to WANRouter and execute the command show controller S0/0
E.Physically examine the cable between WANRouter S0/0 and the DCE
F.Establish a console session on WANRouter and execute the command show interfaces S0/0