Refer to the exhibit. An administrator pings the default gateway at 10.10.10.1 and sees the output as shown. At which OSI layer is the problem?()
A.data link layer
B.application layer
C.access layer
D.session layer
E.network layer
您可能感興趣的試卷
你可能感興趣的試題
A.外部主機202.38.0.50可以PING通任何內部主機
B.內部主機10.10.10.5,可任意訪問外部網絡資源
C.內部任意主機都可以與外部任意主機建立TCP連接
D.外部202.38.5.0/24網段主機可以與此內部網主機TCP連接
E.外部202.38.0.0/24網段主機不可以與此內部同主機建立目標端口號大于1024的TCP連接
Refer to the exhibit. Which command would allow the translations to be created on the router?()
A.ip nat pool mynats 1.1.128.1 1.1.135.254 prefix-length 19
B.ip nat outside mynats 1.1.128.1 1.1.135.254 prefix-length 19
C.ip nat pool mynats 1.1.128.1 1.1.135.254 prefix-length 18
D.ip nat outside mynats 1.1.128.1 1.1.135.254 prefix-length 18
A.IR
B.DSSS
C.FHSS
D.DSSS and FHSS
E.IR, FHSS, and DSSS
A.It designates VLAN 999 for untagged traffic.
B.It blocks VLAN 999 traffic from passing on the trunk.
C.It creates a VLAN 999 interface.
D.It designates VLAN 999 as the default for all unkown tagged traffic.
Refer to the exhibit. What can be determined about the router from the console output?()
A.No configuration file was found in NVRAM.
B.No configuration file was found in flash.
C.No configuration file was found in the PCMCIA card.
D.Configuration file is normal and will load in 15 seconds.
A.172.1.0.0/22
B.172.1.0.0/21
C.172.1.4.0/22
D.172.1.4.0/24 172.1.5.0/24 172.1.6.0/24 172.1.7.0/24
E.172.1.4.0/25 172.1.4.128/25 172.1.5.0/24 172.1.6.0/24 172.1.7.0/24
A.VLAN 1 is the default Ethernet VLAN.
B.CDP advertisements are only sent on VLAN 1002.
C.By default, the management VLAN is VLAN 1005.
D.By default, the switch IP address is in VLAN 1005.
E.VLAN 1002 through 1005 are automatically created and cannot be deleted.
The user of Host1 wants to ping the DSL modem/router at 192.168.1.254. Based on the Host1 ARP table that is shown in the exhibit, what will Host1 do()。
A.send a unicast ARP packet to the DSL modem/router
B.send unicast ICMP packets to the DSL modem/router
C.send Layer 3 broadcast packets to which the DSL modem/router responds
D.send a Layer 2 broadcast that is received by Host2, the switch, and the DSL modem/router
A.It converges quickly.
B.OSPF is a classful routing protocol.
C.It uses cost to determine the best route.
D.It uses the DUAL algorithm to determine the best route.
E.OSPF routers send the complete routing table to all directly attached routers.
F.OSPF routers discover neighbors before exchanging routing information.
A.Router R2 will not form a neighbor relationship with R1.
B.Router R2 will obtain a full routing table, including a default route, from R1.
C.R2 will obtain OSPF updates from R1, but will not obtain a default route from R1.
D.R2 will not have a route for the directly connected serial network, but all other directly connected
最新試題
何時必須使用clock rate 命令配置路由器串行接口?()
請參見圖示。網絡中的主機A 正在向主機B 發送數據段。有關所交換的數據段的流量控制如圖所示。下列關于此通信的陳述,哪兩項是正確的?()
在Cisco IOS 設備中,啟動配置文件存儲于何處?()
請參見圖示。主機A 正在訪問多臺服務器。結合使用什么端口號和地址即可唯一識別特定服務器上運行的特定進程?()
請參見圖示。哪種邏輯拓?fù)涫菍?duì)圖示網絡的準確描述?()
請參見圖示。一臺路由器(其路由表如圖所示)收到發往192.168.1.4的數據包。路由器將如何處理該數據包?()
請參見圖示。下列哪組設備僅包含中間設備?()
請參見圖示。某用戶想要查看當前的配置。圖中所示為ipconfig/all 命令的輸出。從此輸出可以得到哪三項結論?()
請參見圖示。主機B 嘗試與主機C 建立TCP/IP 會話。在嘗試期間,San Francisco 器由器的FastEthernet 接口fa0/1捕獲到一個幀。捕獲的幀中包含源IP 地址為10.10.1.2而目的IP 地址為10.31.1.20的數據包。捕獲該幀時,它的目的MAC 地址是什么?()
請參見圖示。網絡中的所有設備均使用默認配置。此拓?fù)渲写嬖诙嗌賯€(gè)廣播域?()