A.IR
B.DSSS
C.FHSS
D.DSSS and FHSS
E.IR, FHSS, and DSSS

A.It designates VLAN 999 for untagged traffic.
B.It blocks VLAN 999 traffic from passing on the trunk.
C.It creates a VLAN 999 interface.
D.It designates VLAN 999 as the default for all unkown tagged traffic.

A.No configuration file was found in NVRAM.
B.No configuration file was found in flash.
C.No configuration file was found in the PCMCIA card.
D.Configuration file is normal and will load in 15 seconds.

A.172.1.0.0/22
B.172.1.0.0/21
C.172.1.4.0/22
D.172.1.4.0/24 172.1.5.0/24 172.1.6.0/24 172.1.7.0/24
E.172.1.4.0/25 172.1.4.128/25 172.1.5.0/24 172.1.6.0/24 172.1.7.0/24

A.VLAN 1 is the default Ethernet VLAN.
B.CDP advertisements are only sent on VLAN 1002.
C.By default, the management VLAN is VLAN 1005.
D.By default, the switch IP address is in VLAN 1005.
E.VLAN 1002 through 1005 are automatically created and cannot be deleted.

A.send a unicast ARP packet to the DSL modem/router
B.send unicast ICMP packets to the DSL modem/router
C.send Layer 3 broadcast packets to which the DSL modem/router responds
D.send a Layer 2 broadcast that is received by Host2, the switch, and the DSL modem/router

A.It converges quickly.
B.OSPF is a classful routing protocol.
C.It uses cost to determine the best route.
D.It uses the DUAL algorithm to determine the best route.
E.OSPF routers send the complete routing table to all directly attached routers.
F.OSPF routers discover neighbors before exchanging routing information.

A.Router R2 will not form a neighbor relationship with R1.
B.Router R2 will obtain a full routing table, including a default route, from R1.
C.R2 will obtain OSPF updates from R1, but will not obtain a default route from R1.
D.R2 will not have a route for the directly connected serial network, but all other directly connected

A.One router is running RIPv1.
B.RIP neighbor is 224.0.0.9.
C.The network contains a loop.
D.Network 10.10.1.0 is reachable.

A.AH
B.MB5
C.PSK
D.ESP