A.Router R2 will not form a neighbor relationship with R1.
B.Router R2 will obtain a full routing table, including a default route, from R1.
C.R2 will obtain OSPF updates from R1, but will not obtain a default route from R1.
D.R2 will not have a route for the directly connected serial network, but all other directly connected
您可能感興趣的試卷
你可能感興趣的試題
A.One router is running RIPv1.
B.RIP neighbor is 224.0.0.9.
C.The network contains a loop.
D.Network 10.10.1.0 is reachable.
A.AH
B.MB5
C.PSK
D.ESP
A.172.31.17.4 /30
B.172.31.51.16 /30
C.172.31.64.0 /18
D.172.31.80.0 /22
E.172.31.92.0 /22
F.172.31.192.0 /18
A.ipv6 address PREFIX_1::1/64
B.ipv6 autoconfig 2001:db8:2222:7272::72/64
C.ipv6 autoconfig
D.ipv6 address 2001:db8:2222:7272::72/64
A.Network A - 172.16.3.48/26
B.Network A - 172.16.3.128/25
C.Network A - 172.16.3.192/26
D.Link A - 172.16.3.0/30
E.Link A - 172.16.3.40/30
F.Link A - 172.16.3.112/30
What can be determined from the line of show ip route output shown in the exhibit?()
A.The next routing update can be expected in 35 seconds.
B.The IP address 10.10.10.6 is configured on S0/1.
C.The IP address 10.10.10.8 is configured on S0/1.
D.This route is using the default administrative distance.
E.The 10.10.10.8 network is two hops away from this router.
A.access-group
B.access-list
C.acl
D.firewall packet-filter xxxx inbound/outbound
A.the IP address of Switch 1
B.the MAC address of Switch 1
C.the IP address of Host C
D.the MAC address of Host C
E.the IP address of the router's E0 interface
F.the MAC address of the router's E0 interface
A.對端的IP地址和對端的x.121地址
B.對端的IP地址和本接口的x.121地址
C.本接口的IP地址和對端的x.121地址
D.本接口的IP地址和本接口的x.121地址
A.Broadcast frames are never sent to swiches.
B.Broadcast addresses use an incorrect format for the switching table.
C.A broadcast address will never be the source address of a frame.
D.Broadcasts only use network layer addressing.
E.A broadcast frame is never forwarded by a switch.
最新試題
請參見圖示。圖中所示路由表所屬的PC 已正確配置。IP 地址192.168.1.254屬于哪一個網絡設備或接口?()
請參見圖示。電纜1和電纜2分別按照特定的物理層要求接線。哪三個網段使用電纜2?()
請參見圖示。主機X 和主機Y 與本地網絡的通信受到限制。此問題的原因是什么?()
請參見圖示。一臺主機正使用NAT 連接到Internet。下列哪三項IP 地址可實現此連接?()
PC 無法連接到任何遠程網站,無法ping 通其默認網關,也無法ping 通本地網段中工作正常的打印機。以下哪項操作可以確認此PC 上的TCP/IP 協議棧是否工作正常?()
請參見圖示。哪種邏輯拓?fù)涫菍D示網絡的準確描述?()
請參見圖示。一臺路由器(其路由表如圖所示)收到發往192.168.1.4的數據包。路由器將如何處理該數據包?()
以下哪兩種介質可提供高達1Gb/s 的帶寬?()
傳輸層如何讓主機能同時針對不同應用程序維護多個通信流?()
請參見圖示。主機B 嘗試與主機C 建立TCP/IP 會話。在嘗試期間,San Francisco 器由器的FastEthernet 接口fa0/1捕獲到一個幀。捕獲的幀中包含源IP 地址為10.10.1.2而目的IP 地址為10.31.1.20的數據包。捕獲該幀時,它的目的MAC 地址是什么?()