A. signal fail， signal degrade， manual switch
B. signal degrade， signal fail， manual switch
C. protection lockout， manual switch， path AIS
D. forced switch， manual switch， signal degrade
E. protection lockout， manual switch， forced switch
您可能感興趣的試卷
你可能感興趣的試題
A. LEX
B. HDLC
C. GFP-F
D. PPP/BCP
You are provisioning an E-1 circuit on an ONS 15454 MS-SPRing configuration and XC-VXL-10G card. Each VC-12 connection must also terminate via the VC-3 matrix.
How many VC-3 ports remain after this circuit is created， assuming no other circuits？（）
A. 92
B. 93
C. 94
D. 95
E. 96
A. 1+1 is based on APS， while 1：1 is based on IPS.
B. 1：1 is used in SNCP switching， while 1+1 is used in MS-SPRing switching.
C. 1+1 sends signals on Working and Protect paths， while 1：1 sends signals only on Working path.
D. 1+1 sends signals on Working path ONLY， while 1：1 sends signals on both Working and Protect paths.
A. 10
B. 32
C. 64
D. 84
E. 96
A. line timing
B. loop timing
C. internal timing
D. through timing
E. external timing
最新試題
Which three technologies are used to reduce chromatic dispersion accumulation in fiber-optic transmission systems？（）
Which device creates an OEO conversion？ （）
Click the Exhibit button. Within an ONS 15454， you are provisioning a circuit on an unprotected SNCP ring. In the exhibit， which two must you configure？（）
What three in combination are factors that can cause four-wave mixing in fiber-optic cables？（）
If the power is 0 dBm， what is the power in mW？（）
What are three factors that limit the maximum distance of an amplified optical signal without regeneration？ （）
In order to avoid misconnections due to a failed node in an MS-SPRing， Alarm Indication Signals （AISs） are sent on every channel normally terminating in that node. What is the name of this process？（）
The dispersion of a non-zero dispersion shifted fiber is 6 ps/nm*km at 1550 nm and 10 ps/nm*km at 1610 nm. What is the minimum dispersion compensation required if an L-Band DWDM signal travels through 200 km of fiber and has a dispersion tolerance of 1800 ps/nm？（）
What is the difference between the transmitted power and the sensitivity of the receiver？ （）
Click the Exhibit button. The exhibit shows a 15454/15216 DWDM system and alarm indications. What are two possible sources of trouble shown in the system？（）