When optimizing a standalone point-to-multipoint bridge installation with eight non-root bridges.
Which of the following RTS threshold and CWmin settings would be correct for the non-root bridges?()
A.RTS threshold = 1,CWmin = 4
B.RTS threshold = 4000,CWmin = 5
C.RTS threshold = 4000,CWmin = 3
D.RTS threshold = 1,CWmin = 5
您可能感興趣的試卷
你可能感興趣的試題
You review the Failed Attempts logs on an AAA server and find: "unknown network access servererror."
Which failure could produce this error?()
A.AAA client and AAA server handshake failure
B.supplicant authentication failure
C.wrong password used by the supplicant
D.failure of the wireless client and AAA server handshake
During the installation of the Cisco WCS version 4.0, an error occurs.
Where would you look forthe installation log,in order to learn more about this error?()
A.at the root of the installation drive
B.in the Cisco WCS installation directory
C.on the desktop of the server
D.in the Cisco WCS\Logs directory
You are configuring an RF group of controllers that coordinate Radio Resource Management calculations.
What is the maximum number of WLAN controllers that you can add?()
A.17
B.20
C.12
D.24
When configuring a WLAN controller for a voice application using Cisco 7920 wireless IP phones.
Whichtwo general control settings should you select?()
A.Multicast on
B.Aggressive Load Balancing off
C.Multicast off
D.AP Fallback on
E.Aggressive Load Balancing on
You are installing a Cisco 4402 Series Wireless LAN Controller.
Which type of interface shouldyou use on the controller’s distribution port?()
A.1000BASE-SX SFP
B.10/100/1000 Mbps RJ45
C.10/100 Mbps RJ45
D.10000BASE-SX
By default, on the WLAN controller for a voice application using Cisco 7921 wireless IP phones.
What is the percentage of RF bandwidth that can be dedicated to the phones?()
A.75 percent
B.85 percent
C.56 percent
D.55 percent
A.Clients connected to the rogue access point must be able to connect to the containmentcontroller-based access point.
B.Multiple controller-based access points will load-balance the containment task using fewerresourcesthan a single access point.
C.Clients connected to the rogue access point may be out of the range of the controller-basedaccess point providing containment.
D.Each controller-based access point can handle only a limited amount of clients connected tothe rogue access points.
The IOS of a North American Cisco Aironet 1130AG Series standalone access point has becomecorrupt. You must therefore reload the TFTP firmware.
Before you press and hold the MODEbutton,you should verify that the file name is which of the following? ()
A.c1130-k9w7-tar.boot
B.c1130-k9w7-tar.123-7.JA1.tar
C.c1130-k9w7-tar.default
D.c1130-k9w7-tar.recover
A.Problem Management
B.Configuration Management
C.Incident Management
D.Change Management
A.15
B.10
C.1
D.5
最新試題
On a Cisco Aironet 1240AG Series standalone access point, the radio LED is dark blue and blinking,but the status LED and Ethernet LED are both off.What does this indicate?()
Which of the following parameter sets must be configured on the Cisco Wireless Location Appliance?()
The Cisco Wireless Location Appliance provides an audit trail for each device tracked for up to how many days?()
You are troubleshooting a one-way call problem with a Cisco 7920 wireless IP phone on a standalone WLAN.What may cause this problem?()
You have been called upon to add location-based services into an existing controller-basedwireless design which primarily encompasses handheld devices such as barcode scanners and Cisco7920 wireless IP phones.In which mode should you deploy the additional access points to achievethe density required without excessive co-channel interference?()
You are trying to change the polling parameters used by the location manager via the Cisco WCS,and your request is being denied. What is wrong?()
You are using ADU and are authenticated and associated to an access point. However, you are unable to obtain an IP address.Which of these has caused this problem?()
When configuring a WLAN controller for a voice application using Cisco 7920 wireless IP phones,which two general control settings should you select?()
Which protocol does the RADIUS server use inside the secure tunnel of EAP-FAST to authenticatethe client when one-time passwords are in use?()
Static WEP is configured on the access point. You are authenticated and associated to the accesspoint but are unable to obtain an IP address.Which of the following will cause this problem?()