You are installing a Cisco 4402 Series Wireless LAN Controller.
Which type of interface shouldyou use on the controller’s distribution port?()
A.1000BASE-SX SFP
B.10/100/1000 Mbps RJ45
C.10/100 Mbps RJ45
D.10000BASE-SX
您可能感興趣的試卷
你可能感興趣的試題
By default, on the WLAN controller for a voice application using Cisco 7921 wireless IP phones.
What is the percentage of RF bandwidth that can be dedicated to the phones?()
A.75 percent
B.85 percent
C.56 percent
D.55 percent
A.Clients connected to the rogue access point must be able to connect to the containmentcontroller-based access point.
B.Multiple controller-based access points will load-balance the containment task using fewerresourcesthan a single access point.
C.Clients connected to the rogue access point may be out of the range of the controller-basedaccess point providing containment.
D.Each controller-based access point can handle only a limited amount of clients connected tothe rogue access points.
The IOS of a North American Cisco Aironet 1130AG Series standalone access point has becomecorrupt. You must therefore reload the TFTP firmware.
Before you press and hold the MODEbutton,you should verify that the file name is which of the following? ()
A.c1130-k9w7-tar.boot
B.c1130-k9w7-tar.123-7.JA1.tar
C.c1130-k9w7-tar.default
D.c1130-k9w7-tar.recover
A.Problem Management
B.Configuration Management
C.Incident Management
D.Change Management
A.15
B.10
C.1
D.5
A mobility group is created by a Cisco WLCM and 4402 Series Wireless LAN Controller. A clientthat is anchored on the Cisco WLCM roams to an access point on the 4402 controller. You then run adebug command on the 4402 controller.
Which message would best describe the establishment of the tunnel from the foreign controller’sperspective?()
A.Received Mobile Anchor Export message
B.Transmit Plumbing duplex mobility tunnel message
C.Received Plumbing duplex mobility tunnel message
D.Transmit Mobile Anchor Export message
You are charged with implementing a secure wireless installation which will provide Internet
access to client devices but will not allow communications between wireless clients. In addition toimplementing PSPF or peer-to-peer blocking on the wireless side.
Which of the following actionsshould you perform on the wired infrastructure?()
A.Implement a Cisco Secure IPS sensor.
B.Implement 802.1X on the switch ports.
C.Take no action, you have achieved your goal.
D.Implement a protected port on the access switches.
You want to dynamically assign users to an 802.1Q VLAN as a result of their authentication. Inorder to accomplish this.
Which two IETF RADIUS attributes should you configure on the Cisco SecureACS?()
A.083 Tunnel-Preference
B.066 Tunnel-Client-Endpoint
C.064 Tunnel-Type
D.082 Tunnel-Assignment-ID
E.081 Tunnel-Private-Group-ID
F.067 Tunnel-Server-Endpoint
On a Cisco Aironet 1240AG Series standalone access point, the radio LED is dark blue andblinking,but the status LED and Ethernet LED are both off.
What does this indicate()?
A.A firmware upgrade is in progress.
B.An access point buffer overflow is occurring.
C.The access point is booting.
D.The internal radio has failed.
A.router(config-ssid)# enable
B.router(config-ssid)# advertise
C.router(config-ssid)# broadcast
D.router(config-ssid)# guest-mode
最新試題
You have just finished aligning a Cisco Aironet 1400 Series Wireless Bridge link using installationmode. When you set the link back to operational mode you loose association to the root bridge.Which action will correct the problem?()
You review the Failed Attempts logs on an AAA server and find: "unknown network access servererror." Which failure could produce this error?()
You are trying to change the polling parameters used by the location manager via the Cisco WCS,and your request is being denied. What is wrong?()
The Cisco Wireless Location Appliance provides an audit trail for each device tracked for up to how many days?()
Which protocol does the RADIUS server use inside the secure tunnel of EAP-FAST to authenticatethe client when one-time passwords are in use?()
You have been called upon to add location-based services into an existing controller-basedwireless design which primarily encompasses handheld devices such as barcode scanners and Cisco7920 wireless IP phones.In which mode should you deploy the additional access points to achievethe density required without excessive co-channel interference?()
Clients using Cisco-LEAP and EAP-FAST authentication are having no problems logging on to thewireless network, but clients using PEAP are failing to log on.Which situation would result in thistype of problem?()
You are installing a Cisco 4402 Series Wireless LAN Controller.What type of interface is used on the uplink port?()
You have a very few Cisco 7920 wireless IP phones on your network, but lots of wireless laptops.You want to increase the bandwidth available for the laptops by decreasing the bandwidth reserved for the Cisco 7920 phones.What is the lowest percentage of voice-allocated bandwidthyou can select on the WLAN controller?()
Static WEP is configured on the access point. You are authenticated and associated to the accesspoint but are unable to obtain an IP address.Which of the following will cause this problem?()