When implementing MPLS VPNs between CE and PE routers, which of these statements is correct?
As a Network Engineer, it is necessary for you to know how to implement MPLS VPNs between Customer Edge and Provider Edge routers.
Refer to the following descriptions, which one is making sense?（）
A. If using OSPF or EIGRP as the PE-CE routing protocol, redistribution is not required, but any other protocol or static route will require redistribution
B. If using IS-IS as the PE-CE routing protocol, no redistribution is required
C. If using static routes between the CE and PE routers, no redistribution of other VPN routes is required
D. If PE-CE protocol is not BGP, redistribution of other VPN routes from MP-BGP is required
您可能感興趣的試卷
你可能感興趣的試題
A. On the CE router, PE neighbors must be configured in the VRF context on the CE router
B. On PE routers, the CE IBGP neighbors are configured in the global BGP configuration
C. On PE routers, the CE EBGP neighbors are configured in the VRF context
D. A separate BGP process must be used on the PE routers for CE routers so that they do not use the same BGP routing process as that used for the PE router's other provider neighbors
A. EIGRP can be used only as the PE-CE routing protocol if the PE and CE routers are in the same AS
B. Other EIGRP AS routes are automatically advertised to the CE router and do not require a redistribution configuration command to be configured
C. Unlike other routing protocols that are used between PE and CE routers, EIGRP supports backdoor links
D. Configure of the VPN is only required on the PE router
The router SIS-R has been configured in a CIS network. As a network administrator, you were required to enable MPLS on that router.
Which of the following description is making sense on the basis of the output information?（）
A. CEF switching is only needed to forward labeled packets.
B. CEF switching is needed on both ingress and egress interfaces on which MPLS is enabled.
C. Interface-level CEF switching is needed only on egress interfaces that are sending IP packets on which the egress LSR performs the label imposition process.
D. Interface-level CEF switching is needed only on ingress interfaces that are receiving IP packets on which the ingress LSR performs the label imposition process.
A. Cisco Proprietary payload compression
B. Predictor payload compression
C. RTP header compression
D. TCP header compression
A.Version 1
B.Version 5
C.Version 4
D.Version 3
A. By calculating the time offset from the GPS or atomic clock
B. By setting the router clock to the default value if the router can't connect to a time server
C. By setting all network devices to the correct time
D. By setting necessary time date in the timestamp information
Which of the following can we draw from the given information concerning the class-map "all-traffic"?（）
A. The class-map "all-traffic" will match all traffic with ip precedence 4 and 5
B. The class-map "all-traffic" will match all traffic with dscp 18 or dscp 43
C. The class-map "all-traffic" will match all traffic with ip precedence 0 or 1
D. The class-map "all-traffic" will match all traffic with dscp 18 and dscp 43
A. CIS 1# show class-map forward Class map match-all forward ( id 3) Match ip dscp 18
B. CIS1#show access-map block Class map match-all block (id 4) Match ip dscp 43
C. CIS1# show class-map real-time Class map match-all block (id 5) Match ip dscp 16
D. CIS 1# show class-map pass Class map match-all real-time (id 2) Match ip dscp 40
You are an experienced network administrator in an international company. During your working hours, customers complain that they experience intermittent data loss and they intermittently fail to connect to crucial servers. As shown in the following topology, the 802.1Q trunk between DSW111 and ASW1 fails. Though DSW112 is in the service of HSRP group 11, the SVI for VLAN 11 is up on DSW111.
So as to figure out the problem,
which three commands should you issue on DSW111? （）(Choose three.)
A. show standby vlan 11 brief
B. show interfaces vlan 11
C. show spanning-tree vlan 11
D. show interfaces
You are troubleshooting an issue which is causing full-sized packets entering the MPLS cloud be dropped. You have discovered that one of the switches in the MPLS core is not a Cisco switch, but otherwise the MPLS MTU size is set to 1508 bytes on the routers.
Based on this information, which of these may be the reason the packets are being dropped?（）
A. The switch on you MPLS core that was not produced by Cisco does not support oversized packets
B. No switches support oversized packets
C. By definition, the maximum MTU is 1500 bytes
D. As MPLS VPN labeling increases the size of the packet by 8 bytes, the IP MTU should have been changed to 1508
最新試題
Refer to the exhibit. Which two of these statements are correct? (Choose two.)（）
Which three of these items are IPv6 transition mechanisms? （）(Choose three.)
Which command is used to view IPv6 parameters related to the BGP process?（）
Which configuration will enable OSPF for IPv6 on FastEthernet 0/0/0?（）
Which description is making sense on the basis of the given information?（）
Which of the following is an easy-to-use tool that allows you to easily configure and monitor Cisco Integrated Services Routers?（）
Refer to the exhibit. Which two of these events will be the result of issuing the above command? （）(Choose two.)
As an experienced technician, you are responsible for Technical Support in your company. One of the trainees is asking you which Cisco VPN Acceleration Module for Cisco 7200 Series routers and the Cisco 7301 provides high-performance encryption/compression and supports the latest encryption standard.Which of the following will answer his question?（）
Refer to the exhibit. You have a non-Cisco switch that is not communicating properly while connected to the distribution-layer Cisco switching fabric.Which two best-practice actions can you take to overcome this problem? （）(Choose two.)
What is the function of the no switchport catalyst switch interface configuration command?（）