A. CIS 1# show class-map forward Class map match-all forward ( id 3) Match ip dscp 18
B. CIS1#show access-map block Class map match-all block (id 4) Match ip dscp 43
C. CIS1# show class-map real-time Class map match-all block (id 5) Match ip dscp 16
D. CIS 1# show class-map pass Class map match-all real-time (id 2) Match ip dscp 40
您可能感興趣的試卷
你可能感興趣的試題
You are an experienced network administrator in an international company. During your working hours, customers complain that they experience intermittent data loss and they intermittently fail to connect to crucial servers. As shown in the following topology, the 802.1Q trunk between DSW111 and ASW1 fails. Though DSW112 is in the service of HSRP group 11, the SVI for VLAN 11 is up on DSW111.
So as to figure out the problem,
which three commands should you issue on DSW111? ()(Choose three.)
A. show standby vlan 11 brief
B. show interfaces vlan 11
C. show spanning-tree vlan 11
D. show interfaces
You are troubleshooting an issue which is causing full-sized packets entering the MPLS cloud be dropped. You have discovered that one of the switches in the MPLS core is not a Cisco switch, but otherwise the MPLS MTU size is set to 1508 bytes on the routers.
Based on this information, which of these may be the reason the packets are being dropped?()
A. The switch on you MPLS core that was not produced by Cisco does not support oversized packets
B. No switches support oversized packets
C. By definition, the maximum MTU is 1500 bytes
D. As MPLS VPN labeling increases the size of the packet by 8 bytes, the IP MTU should have been changed to 1508
A. Layer 2 TTL
B. Layer 3 TTL
C. Layer 3 source address
D. Layer 3 destination address
A. Show module
B. Show errdisable detect
C. Show environment
D. Show diagnostic content
A Catalyst switch has just been installed and configured, and is not working as expected. You have decided to capture multiple show command outputs to study.
Which one command could you use that includes the output of many other show commands, such as show version and show running-config?()
A. show configuration
B. show memory
C. show stacks
D. show tech-support
As an experienced Network Engineer, you are required to implement the security architecture assessment.
Which of the following statement describes the most important reason for that?()
A. Create a design specification document.
B. Integrate routing and switching components.
C. Document power and UPS availability
D. Document the customer's current and future technology projects.
The Cisco Enterprise Campus Architecture increases the effectiveness of networked applications and services on campus, enabling enterprises to grow their business and stay ahead.
What is the outcome of designing all its components with taking interoperability into consideration?()
A. improved connectivity options
B. strengthened security
C. high availability
D. continuity of service
As an experienced network administrator, you are aware of the knowledge that it is unnecessary to configure complex overlay network topologies while applying Cisco Wide Area Application Services (WAAS) technology.
What is most probably the reason for that?()
A. Content pre-positioning
B. Automatic discovery of Cisco WAEs
C. Comprehensive logs, reports, and graphs
D. Remote scheduling of software distribution
As an experienced network administrator, you are aware of the knowledge that it is unnecessary to configure complex overlay network topologies while applying Cisco Wide Area Application Services (WAAS) technology.
What is most probably the reason for that?()
A. Content pre-positioning
B. Automatic discovery of Cisco WAEs
C. Comprehensive logs, reports, and graphs
D. Remote scheduling of software distribution
Cisco IOS is the software used on the vast majority of Cisco Systems routers and current Cisco network switches. As a network administrator, you are required to configure MPLS on Cisco IOS. In such a situation,
which three of the following steps are necessary to take?()
A. Start LDP.
B. Enable CEF switching.
C. Configure conditional label advertising.
D. Enable label switching on frame mode interfaces.
E. disable IP TTL propagation
F. configure conditional label advertising
最新試題
You have just reinstalled a VIP 6-80 in a Cisco 7500 Series router. What must you do to bring up the port adapter interfaces?()
As an experienced network engineer, you are asked to troubleshoot a CIS network outage. During the troubleshooting process, you notice that one of your colleagues connects additional devices to the network with the use of his own switch. With the purpose of improving speed, the switch is attached to both network ports in an office, which leads to bridge loop.Enabling which of the following feature will be able to prevent this problem from happening again?()
When a Cisco router is configured for SSH, it acts as an ()?
Which description is making sense on the basis of the given information?()
Referring to the partial Cisco Catalyst switch configuration shown, which two of these statements are correct? ()(Choose two.)
Refer to the exhibit. Analyze the two traceroutes that are displayed. Which of these statements is correct in describing what most likely caused the traceroute differences?()
Which of the following is an easy-to-use tool that allows you to easily configure and monitor Cisco Integrated Services Routers?()
Which keyword is used with the show ip bgp neighbors [keyword] command to display all routes that are received and accepted from a neighbor?()
With a VPN Accelerator Module 2+ (VAM2+) installed in a Cisco 7200 series router, what will be the resulting action when entering the command no crypto engine accelerator slot number?()
On the Catalyst 6500 Series switch, which command is used to establish a console connection to the Firewall Services Module?()