The router SIS-R has been configured in a CIS network. As a network administrator, you were required to enable MPLS on that router.
Which of the following description is making sense on the basis of the output information?()
A. CEF switching is only needed to forward labeled packets.
B. CEF switching is needed on both ingress and egress interfaces on which MPLS is enabled.
C. Interface-level CEF switching is needed only on egress interfaces that are sending IP packets on which the egress LSR performs the label imposition process.
D. Interface-level CEF switching is needed only on ingress interfaces that are receiving IP packets on which the ingress LSR performs the label imposition process.
您可能感興趣的試卷
你可能感興趣的試題
A. Cisco Proprietary payload compression
B. Predictor payload compression
C. RTP header compression
D. TCP header compression
A.Version 1
B.Version 5
C.Version 4
D.Version 3
A. By calculating the time offset from the GPS or atomic clock
B. By setting the router clock to the default value if the router can't connect to a time server
C. By setting all network devices to the correct time
D. By setting necessary time date in the timestamp information
Which of the following can we draw from the given information concerning the class-map "all-traffic"?()
A. The class-map "all-traffic" will match all traffic with ip precedence 4 and 5
B. The class-map "all-traffic" will match all traffic with dscp 18 or dscp 43
C. The class-map "all-traffic" will match all traffic with ip precedence 0 or 1
D. The class-map "all-traffic" will match all traffic with dscp 18 and dscp 43
A. CIS 1# show class-map forward Class map match-all forward ( id 3) Match ip dscp 18
B. CIS1#show access-map block Class map match-all block (id 4) Match ip dscp 43
C. CIS1# show class-map real-time Class map match-all block (id 5) Match ip dscp 16
D. CIS 1# show class-map pass Class map match-all real-time (id 2) Match ip dscp 40
You are an experienced network administrator in an international company. During your working hours, customers complain that they experience intermittent data loss and they intermittently fail to connect to crucial servers. As shown in the following topology, the 802.1Q trunk between DSW111 and ASW1 fails. Though DSW112 is in the service of HSRP group 11, the SVI for VLAN 11 is up on DSW111.
So as to figure out the problem,
which three commands should you issue on DSW111? ()(Choose three.)
A. show standby vlan 11 brief
B. show interfaces vlan 11
C. show spanning-tree vlan 11
D. show interfaces
You are troubleshooting an issue which is causing full-sized packets entering the MPLS cloud be dropped. You have discovered that one of the switches in the MPLS core is not a Cisco switch, but otherwise the MPLS MTU size is set to 1508 bytes on the routers.
Based on this information, which of these may be the reason the packets are being dropped?()
A. The switch on you MPLS core that was not produced by Cisco does not support oversized packets
B. No switches support oversized packets
C. By definition, the maximum MTU is 1500 bytes
D. As MPLS VPN labeling increases the size of the packet by 8 bytes, the IP MTU should have been changed to 1508
A. Layer 2 TTL
B. Layer 3 TTL
C. Layer 3 source address
D. Layer 3 destination address
A. Show module
B. Show errdisable detect
C. Show environment
D. Show diagnostic content
A Catalyst switch has just been installed and configured, and is not working as expected. You have decided to capture multiple show command outputs to study.
Which one command could you use that includes the output of many other show commands, such as show version and show running-config?()
A. show configuration
B. show memory
C. show stacks
D. show tech-support
最新試題
Which Cisco IOS command is used to troubleshoot a problem in which a BGP session stays in the active state?()
On the Catalyst 6500 Series switch, which command is used to establish a console connection to the Firewall Services Module?()
What is the purpose of using VPN hardware acceleration equipment?()
As a network administrator, you issue the interface auto qos voip cisco-phone command on a port in an edge network. It is possible for a Cisco Catalyst switch to check if a Cisco IP Phone is directly attached to that port by:()
What are four advantages to using tunnel brokers in an IPv6 transition environment?()
You are trying to initiate an SSH connection to a remote router and are getting rejected with an error code of 0. Which of these might be the cause of the error?()
What is the maximum number of Cisco Catalyst 3750 Series Switches that can be united into a single manageable unit using the Cisco StackWise technology?()
You are an experienced network administrator in an international corporation. One of your clients asks you to configure a network for a financial trading center which requires multiple high-value transactions.And the transactions are very important to the client. In such a situation, which two of the following are basic and most important requirements concerning the configuration? ()(Choose two.)
Which configuration will enable OSPF for IPv6 on FastEthernet 0/0/0?()
Which command is used to view IPv6 parameters related to the BGP process?()