An reap was supporting 16 wlans， but now it only supports one.
What happened to cause the change？（）
A.controller connectivity has been lost.
B.the access point lost its configuration.
C.the access point was rebooted.
D.an access point firmware upgrade is in progress.
您可能感興趣的試卷
你可能感興趣的試題
A rogue access point is detected on the cisco wcs consolE. upon investigation，the access point is discovered to belong to a neighboring business.
Your administrator should designate the rogue access point as which of the following？（）
A.known internal
B.managed
C.friendly
D.known external
A.30 mw
B.100 mw
C.40 mw
D.50 mw
A.rts
B.distance（kilometers）
C.concatenation
D.cca
Your client has deployed a cisco wireless location appliance within their warehouse environment. they have been experiencing problems with tracking objects using active rfid tags. to verify proper access point deployment for location server.
The results from an access point scan should show what information？（）
A.a minimum rssi value of -50
B.rogue access points
C.a minimum of three access points
D.non-overlapping channels
A.device type and subnet
B.mac address and device type
C.serial number and version number
D.serial number and subnet
A.lost connection to the controller
B.duplicate ip address
C.startup
D.site survey mode
A.enable self-healing.
B.configure location manager.
C.conduct client walkabout.
D.conduct radio scan.
A.disable auto rf and configure manually.
B.disable all 802.11b data rates.
C.power access point to full power.
D.hard code the channel.
A.infrastructure devices to associate only to this ssid
B.enable ip redirection on this ssid
C.set data beacon rate
D.multiple basic service set identification （bssid）
E.set infrastructure ssid
A.eap-peap
B.eap-fast
C.eap-cisco wireless （leap）
D.eap-tls
E.eap-md5
最新試題
Which protocol does the RADIUS server use inside the secure tunnel of EAP-FAST to authenticatethe client when one-time passwords are in use？（）
You have just finished aligning a Cisco Aironet 1400 Series Wireless Bridge link using installationmode. When you set the link back to operational mode you loose association to the root bridge.Which action will correct the problem？（）
You are trying to change the polling parameters used by the location manager via the Cisco WCS，and your request is being denied. What is wrong？（）
When configuring a WLAN controller for a voice application using Cisco 7920 wireless IP phones，which two general control settings should you select？（）
You are charges with implementing a secure wireless installation which will provide Internet accessto client devices but will not allow communications between wireless clients.In addition to implementing PSPF or peer-to-peer blocking on the wireless side，which of the following actionsshould you perform on the wired infrastructure？（）
When configuring Cisco Secure ACS to support wireless EAP authentication， which device must be configured as a AAA client？（）
A Cisco WCS version 4.0 has been installed on a server with a dual Pentium 3.0 GHz processor，4GB RAM， and an 80 GB hard drive. A location appliance has been incorporated into the networkand is being monitored by the Cisco WCS. There are 3000 devices to be tracked but not all of themare being tracked on the Cisco WCS.What can be done to correct the problem？（）
You are troubleshooting a one-way call problem with a Cisco 7920 wireless IP phone on a standalone WLAN.What may cause this problem？（）
The IOS of a North American Cisco Aironet 1130AG Series standalone access point has becomecorrupt. You must therefore reload the TFTP firmware.Before you press and hold the MODEbutton， you should verify that the file name is which of the following？（）
You have a very few Cisco 7920 wireless IP phones on your network， but lots of wireless laptops.You want to increase the bandwidth available for the laptops by decreasing the bandwidth reserved for the Cisco 7920 phones.What is the lowest percentage of voice-allocated bandwidthyou can select on the WLAN controller？（）