You are using adu and are authenticated and associated to an access point. you are unable to obtain an ip address.
Which of the following will cause this problem？（）
A.aes encryption enabled
B.tkip enabled
C.third-party wireless supplicant enabled
D.802.1x authentication type enabled
您可能感興趣的試卷
你可能感興趣的試題
On a series 1010 lightweight access point， the alarm led is flashing red， and all other leds are off.
What is the lightweight access point indicating？（）
A.it has lost contact with controller.
B.its ip address already exists.
C.it requires a code upgrade.
D.it is operating normally.
A.router# show wlccp ap
B.router# show wlccp wds ap
C.router# show wlccp cckm
D.router# show wlccp wds cckm
A.dictionary
B.bit-flip and replay
C.mac spoofing
D.man-in-the-middle
A.https
B.tftp
C.rmi
D.http
E.ftp
A.shut down rogue access points
B.configure access points
C.discover access points
D.inventory access points
Using the wlse,you are trying to push out a configuration job to an access point,but the job does not start.
Which of the following would cause this failure？（）
A.invalid parameter in the template
B.incorrect snmp communities on the access point
C.unsupported version of ios firmware in the access point
D.pop-up blocker enabled in the browser
A.75
B.100
C.25
D.50
Client association using eap-cisco wireless （leap） is failing， but eap-peap is functioning on an autonomous access point.
Which of the following needs to be enabled on the access point so eap-cisco wireless （leap） is enabled？（）
A.open authentication plus mac
B.open authentication plus eap
C.shared key
D.network eap
A.devices
B.ids
C.configure
D.reports
In a network using cisco autonomous access points running wds.
What port is used for authentication by the local authentication service on an access point？（）
A.1813
B.1645
C.1646
D.1812
最新試題
The Cisco Wireless Location Appliance provides an audit trail for each device tracked for up to how many days？（）
You are installing a Cisco 4402 Series Wireless LAN Controller.What type of interface is used on the uplink port？（）
You have a very few Cisco 7920 wireless IP phones on your network， but lots of wireless laptops.You want to increase the bandwidth available for the laptops by decreasing the bandwidth reserved for the Cisco 7920 phones.What is the lowest percentage of voice-allocated bandwidthyou can select on the WLAN controller？（）
A client roams from H-REAP AP1 to H-REAP AP2. The client is unable to associate to H-REAP AP2.H-REAP AP2 has six other clients associated to it， which continue to pass traffic.What has causedthis problem？（）
Which of the following commands on the wireless interface of a Cisco 3845 Integrated Service Router allows the SSID to broadcast？（）
You are charges with implementing a secure wireless installation which will provide Internet accessto client devices but will not allow communications between wireless clients.In addition to implementing PSPF or peer-to-peer blocking on the wireless side，which of the following actionsshould you perform on the wired infrastructure？（）
A mobility group is created by a Cisco WLCM and 4402 Series Wireless LAN Controller. A client thatis anchored on the Cisco WLCM roams to an access point on the 4402 controller. You then run adebug command on the 4402 controller.Which message would best describe the establishment ofthe tunnel from the foreign controller’s perspective？（）
Which of the following parameter sets must be configured on the Cisco Wireless Location Appliance？（）
You are troubleshooting a problem with a Cisco 7920 wireless IP phone that is causing the phoneto drop calls. The problem appears to be roaming bandwidth issue. In order to verify what kind ofissue it is， you decide to increase the bandwidth reserve for roaming on the WLAN controller tomaximum.What level do you set the bandwidth to？（）
On a WLAN controller， what is the default roaming bandwidth percentage reserved for voice clients？（）