A.shut down rogue access points
B.configure access points
C.discover access points
D.inventory access points
您可能感興趣的試卷
你可能感興趣的試題
Using the wlse,you are trying to push out a configuration job to an access point,but the job does not start.
Which of the following would cause this failure?()
A.invalid parameter in the template
B.incorrect snmp communities on the access point
C.unsupported version of ios firmware in the access point
D.pop-up blocker enabled in the browser
A.75
B.100
C.25
D.50
Client association using eap-cisco wireless (leap) is failing, but eap-peap is functioning on an autonomous access point.
Which of the following needs to be enabled on the access point so eap-cisco wireless (leap) is enabled?()
A.open authentication plus mac
B.open authentication plus eap
C.shared key
D.network eap
A.devices
B.ids
C.configure
D.reports
In a network using cisco autonomous access points running wds.
What port is used for authentication by the local authentication service on an access point?()
A.1813
B.1645
C.1646
D.1812
A.20
B.5
C.15
D.10
A.chooses the least congested channel
B.uses the configured channel
C.sets all access points to the same channel
D.steps through each of the allowed channels
A.eap-fast master server
B.allow automatic pac provisioning
C.client initial message
D.authority id info
A.two
B.three
C.four
D.one
On a cisco aironet 1230 series autonomous access point, the status led is solid red, and the ethernet and radio leds are both off.
What does this indicate?()
A.a firmware upgrade is in progress.
B.the internal radio has failed.
C.an access point buffer overflow is occurring.
D.the access point is booting.
最新試題
You have a very few Cisco 7920 wireless IP phones on your network, but lots of wireless laptops.You want to increase the bandwidth available for the laptops by decreasing the bandwidth reserved for the Cisco 7920 phones.What is the lowest percentage of voice-allocated bandwidthyou can select on the WLAN controller?()
When configuring a WLAN controller for a voice application using Cisco 7920 wireless IP phones,which two general control settings should you select?()
A client roams from H-REAP AP1 to H-REAP AP2. The client is unable to associate to H-REAP AP2.H-REAP AP2 has six other clients associated to it, which continue to pass traffic.What has causedthis problem?()
You are troubleshooting a problem with a Cisco 7920 wireless IP phone on a standalone WLAN.The phone rings but, when you answer, the call is dropped.What may cause this problem?()
You are troubleshooting a one-way call problem with a Cisco 7920 wireless IP phone on a standalone WLAN.What may cause this problem?()
A Cisco WCS version 4.0 has been installed on a server with a dual Pentium 3.0 GHz processor,4GB RAM, and an 80 GB hard drive. A location appliance has been incorporated into the networkand is being monitored by the Cisco WCS. There are 3000 devices to be tracked but not all of themare being tracked on the Cisco WCS.What can be done to correct the problem?()
The IOS of a North American Cisco Aironet 1130AG Series standalone access point has becomecorrupt. You must therefore reload the TFTP firmware.Before you press and hold the MODEbutton, you should verify that the file name is which of the following?()
A Cisco Wireless Location Appliance has been added to track RFID tags placed on laptops beingused in a school.Classrooms at the school have concrete block walls. During testing,you discoverthat the accuracy of the system needs to be improved.You decide to edit the map in the Cisco WCS to add the interior walls.How many interior walls can you add to improve the accuracy of thelocation appliance?()
How many WLANs can a Cisco Aironet 1242 in H-REAP mode support when actively connected toa wireless controller?()
An REAP was supporting 16 WLANs, but now it only supports one.What happened to cause the change?()