A.75
B.100
C.25
D.50
您可能感興趣的試卷
你可能感興趣的試題
Client association using eap-cisco wireless （leap） is failing， but eap-peap is functioning on an autonomous access point.
Which of the following needs to be enabled on the access point so eap-cisco wireless （leap） is enabled？（）
A.open authentication plus mac
B.open authentication plus eap
C.shared key
D.network eap
A.devices
B.ids
C.configure
D.reports
In a network using cisco autonomous access points running wds.
What port is used for authentication by the local authentication service on an access point？（）
A.1813
B.1645
C.1646
D.1812
A.20
B.5
C.15
D.10
A.chooses the least congested channel
B.uses the configured channel
C.sets all access points to the same channel
D.steps through each of the allowed channels
A.eap-fast master server
B.allow automatic pac provisioning
C.client initial message
D.authority id info
A.two
B.three
C.four
D.one
On a cisco aironet 1230 series autonomous access point， the status led is solid red， and the ethernet and radio leds are both off.
What does this indicate？（）
A.a firmware upgrade is in progress.
B.the internal radio has failed.
C.an access point buffer overflow is occurring.
D.the access point is booting.
A.8
B.32
C.4
D.16
On a cisco aironet 1130 series autonomous access point， the status indicator is blinking dark blue.
What does this indicate？（）
A.the access point is booting.
B.a firmware upgrade is in progress.
C.the internal radio has failed.
D.an access point buffer overflow is occurring.
最新試題
You are installing a Cisco 4402 Series Wireless LAN Controller.What type of interface is used on the uplink port？（）
You have been called upon to add location-based services into an existing controller-basedwireless design which primarily encompasses handheld devices such as barcode scanners and Cisco7920 wireless IP phones.In which mode should you deploy the additional access points to achievethe density required without excessive co-channel interference？（）
If it is properly deployed， a controller-based access point is capable of monitoring all VLANs on anetwork when you select which of the following modes from the AP Mode drop-down menu onthe controller？（）
When configuring a WLAN controller for a voice application using Cisco 7920 wireless IP phones，which two general control settings should you select？（）
You are using ADU and are authenticated and associated to an access point. However， you are unable to obtain an IP address.Which of these has caused this problem？（）
What is the maximum number of wireless controllers that the highest-end Cisco WCS server canmanage？（）
Which protocol does the RADIUS server use inside the secure tunnel of EAP-FAST to authenticatethe client when one-time passwords are in use？（）
Clients using Cisco-LEAP and EAP-FAST authentication are having no problems logging on to thewireless network， but clients using PEAP are failing to log on.Which situation would result in thistype of problem？（）
A Cisco WCS version 4.0 has been installed on a server with a dual Pentium 3.0 GHz processor，4GB RAM， and an 80 GB hard drive. A location appliance has been incorporated into the networkand is being monitored by the Cisco WCS. There are 3000 devices to be tracked but not all of themare being tracked on the Cisco WCS.What can be done to correct the problem？（）
On a Cisco Aironet 802.11 a/b/g wireless LAN client adapter，the status LED and activity LED are alternating on and off.What does this indicate？（）