A.100 mW, 24 Mb/s
B.100 mW, 18 Mb/s
C.25 mW, 18 Mb/s
D.3.2 mW, 54 Mb/s
您可能感興趣的試卷
你可能感興趣的試題
A.In a multifloor building, the access point layout from the survey of one floor can be directly applied to the remaining floors
B.Access points can be installed in the same place on every floor, without worrying about co-channelinterference
C.You can survey with a Cisco AIR-ANT5959 in a plenum environment
D.Identify all hazardous and restricted areas that might require extra or special survey and installationwork
A.Active mode does not require the client to be specifically confgured
B.Passive mode can survey more than one access point at a time
C.Active mode yields signal-quality information such as packet retries and lost packets
D.Active mode requires more time to survey but yields more information results than passive mode does
A.20 percent cell overlap
B.four access points detecting a client at -76 dBm or better
C.10 percent cell overlap
D.three access points detecting a client at -75 dBm or better
A.at 30mW
B.matched to the antenna gain
C.differing by at least 20 dBi
D.matched to each other
A.access point position, in feet, from a corner of the floor plan
B.SNR coverage map for 802.11a/n
C.data rate map for 802.11a/n
D.percent of coverage by signal
A.TIFF
B.DXF
C.PNG
D.DWG
A.per SSID
B.per access point
C.globally
D.per WLAN and radio
A.Fresnel units
B.decibels
C.EIRP
D.milliamperes
E.ohms
A.rogue access point detection in the coverage area
B.multipath issues in the coverage area
C.number of VoWLAN users in the coverage cell
D.call capacity requirements of the coverage area
A.green
B.blue
C.yellow
D.red
E.purple
F.white
最新試題
When conducting a wireless voice site survey, which two sizing considerations exist for thecoverage cell?()
When surveying for VoWLAN, which power level should you base the access point coverage designon?()
A design requires 100 access points with high channel bandwidth and disabled lower data rates.How are the data rates set on the Cisco WLC and Cisco WCS?()
In which three frequency bands does the Cisco Spectrum Expert Wi-Fi tool perform spectrumanalysis? ()
What is a site survey best practice for location-based services?()
How should the transmit power on an access point and client each be set during a site survey?()
Given the correct input parameters, the Cisco WCS Planning Tool can calculate a recommendedaccess point count for which three uses? ()
Which class of Cisco access points operate under IEEE 802.3af power?()
How is attenuation measured?()
The Cisco Aironet 1140 Series Access Point draws 12.95 W at the power source. However, whenusing a long Ethernet cable, the device can draw up to how much additional wattage?()