A.0.25 W
B.0.45 W
C.1 W
D.1.25 W
E.2.45 W
F.5.65 W
您可能感興趣的試卷
你可能感興趣的試題
A.#6 solid copper
B.#12 solid copper
C.#20 solid copper
D.#22 solid copper
A.1/6
B.1/4
C.1/3
D.1/2
A.less than 10 percent
B.10 to 15 percent
C.15 to 20 percent
D.25 to 30 percent
A.Class A
B.Class 1
C.Class 2
D.Class 3
E.Class 4
A.5 to 10 percent for both 2.4 GHz and 5 GHz
B.10 percent for both 2.4 GHz and 5 GHz
C.20 percent for 2.4 GHz and 15 to 20 percent for 5 GHz
D.20 percent for 2.5 GHz and 10 percent for 5 GHz
A.1， 4， 7， 11
B.1， 4， 8. 11
C.1， 6， 11， 1
D.2， 4， 6， 8
A.AP1130
B.AP1242
C.AP1252
D.BR1310
A.Cisco WCS supports third-party antennas for location applications.
B.Access points that are defined with third-party antennas will not participate in rogue on-demand location tracking.
C.Cisco WCS supports third-party antenna gain， azimuth， and elevation progation patterns.
D.Access points that are defined with a third-party antenna in Cisco WCS will display coverage heat maps.
A.Max RF bandwidth is 75 percent， reserved roaming bandwidth is 6 percent.
B.Max RF bandwidth is 50 percent， reserved roaming bandwidth is 10 percent.
C.Max RF bandwidth is 50 percent， reserved roaming bandwidth is 15 percent.
D.Max RF bandwidth is 0 percent， reserved roaming bandwidth is 0.
A.NEMA area
B.plenum area
C.DAS area
D.extended area
E.RF special area
最新試題
Given the correct input parameters， the Cisco WCS Planning Tool can calculate a recommendedaccess point count for which three uses？ （）
When planning for voice deployments with the Cisco Unified Wireless IP Phone 7921G handset in amultifloor building with a WLAN that operates at an 11 MB/s data rate， how many decibelsreferenced to 1 milliwatt of same-channel separation are recommended between floors？（）
In which three frequency bands does the Cisco Spectrum Expert Wi-Fi tool perform spectrumanalysis？ （）
How is attenuation measured？（）
What should be done if Cisco Spectrum Expert Wi-Fi reports a channel utilization of 40 percent onchannel 36， from a source outside of the site？（）
What is a site survey best practice for location-based services？（）
In an outdoor bridge link， what is calculated by using this formula： transmitter power + antennagain - insertion OR cable loss（）？
Which three formats can be used to import floor maps in Cisco WCS v5.2？（）
When using a lightning arrestor， connect which type of ground wire to a good earth ground？（）
After the site installation is complete， you should verify the mobility of the VoWLAN device whilewalking the site on an active phone call. Which Cisco WLC or Cisco WCS command is mostbeneficial in determining roaming efficiency？（）