A.In a multifloor building， the access point layout from the survey of one floor can be directly applied to the remaining floors
B.Access points can be installed in the same place on every floor， without worrying about co-channelinterference
C.You can survey with a Cisco AIR-ANT5959 in a plenum environment
D.Identify all hazardous and restricted areas that might require extra or special survey and installationwork
您可能感興趣的試卷
你可能感興趣的試題
A.Active mode does not require the client to be specifically confgured
B.Passive mode can survey more than one access point at a time
C.Active mode yields signal-quality information such as packet retries and lost packets
D.Active mode requires more time to survey but yields more information results than passive mode does
A.20 percent cell overlap
B.four access points detecting a client at -76 dBm or better
C.10 percent cell overlap
D.three access points detecting a client at -75 dBm or better
A.at 30mW
B.matched to the antenna gain
C.differing by at least 20 dBi
D.matched to each other
A.access point position， in feet， from a corner of the floor plan
B.SNR coverage map for 802.11a/n
C.data rate map for 802.11a/n
D.percent of coverage by signal
A.TIFF
B.DXF
C.PNG
D.DWG
A.per SSID
B.per access point
C.globally
D.per WLAN and radio
A.Fresnel units
B.decibels
C.EIRP
D.milliamperes
E.ohms
A.rogue access point detection in the coverage area
B.multipath issues in the coverage area
C.number of VoWLAN users in the coverage cell
D.call capacity requirements of the coverage area
A.green
B.blue
C.yellow
D.red
E.purple
F.white
A.SNR
B.noise floor
C.level of interference
D.Received Signal Strength Indicator
最新試題
Which statement about active and passive surveys is incorrect？（）
A design requires 100 access points with high channel bandwidth and disabled lower data rates.How are the data rates set on the Cisco WLC and Cisco WCS？（）
Which class of Cisco access points operate under IEEE 802.3af power？（）
For an active Cisco Unified Wireless IP Phone 7921G 5 GHz site survey， what are the mostappropriate client test settings to use with the AirMagnet site survey tool？（）
What will cause wireless voice devices to perform poorly？（）
When planning for VoWLAN capacity during a site survey， how many simultaneous calls can beestimated per 5 GHz channel？（）
Which two methods can be used to prevent or reduce RFI from colocated directional antennas（）
When using a lightning arrestor， connect which type of ground wire to a good earth ground？（）
Which antenna generally has the narrowest first Fresnel zone in both the horizontal and verticalplanes？（）
Which three items does the Cisco WCS Planning Tool Generate Proposal Report provide？（）