A.Transmit only
B.Diversity
C.Receive only
D.Single isolated antenna
您可能感興趣的試卷
你可能感興趣的試題
A.LOS modulation
B.Multipath distortion
C.RF signal absorption
D.RF signal attenuation
E.Fresnel zone impedance
A.Add a new 802.11a WLAN
B.Increase the Layer 2 and Layer 3 security of the WLAN
C.Increase the throughput for the wireless clients
D.Add new services (such as voice) over the WLAN
A.Identify potential problem areas
B.Define intended coverage areas
C.Access compliance with local building codes
D.Determine the final location of APs and antennas
E.Identify sources of RF signal attenuation and RF interference
A.Implementation suggestions
B.Access point locations
C.Security requirements
D.Access point mounting methods
A.Access point received-signal strength level
B.Spectrum utilization
C.Client data rate
D.In-band radio frequency interference
A.300
B.448
C.664
D.1800
E.2400
最新試題
Which can NOT be selected for supported services in Cisco WCS Planning Tool?()
The Cisco Aironet 1140 Series Access Point draws 12.95 W at the power source. However, whenusing a long Ethernet cable, the device can draw up to how much additional wattage?()
What does a broad-spectrum interferer lower?()
For an active Cisco Unified Wireless IP Phone 7921G 5 GHz site survey, what are the mostappropriate client test settings to use with the AirMagnet site survey tool?()
Which three device types are identified by Cisco Spectrum Expert Wi-Fi finding an Avg PulseDuration parameter?()
Which three formats can be used to import floor maps in Cisco WCS v5.2?()
Cisco recommends a decibel referenced to 1 milliwatt signal level for the coverage cell edge at thepredetermined data rate that is needed to support the VoWLAN device and call capacityrequirements. What is that signal level value for Cisco Unified Wireless IP Phones 7920, 7921G, and7925G?()
How is attenuation measured?()
Which three colors are used in the Cisco WCS v5.2 Voice Readiness Tool?()
After the site installation is complete, you should verify the mobility of the VoWLAN device whilewalking the site on an active phone call. Which Cisco WLC or Cisco WCS command is mostbeneficial in determining roaming efficiency?()