A. Features such as UplinkFast and BackboneFast are compatible with RSTP.
B. An RSTP that is based on Cisco products generally performs better than the Cisco proprietary 802.1D enhancements.
C. Cisco proprietary enhancements are not transparent.
D. Information about port roles is sent to all switches.
E. RSTPs that are based on Cisco products require no additional configuration.
您可能感興趣的試卷
你可能感興趣的試題
A. Implement threshold monitoring using RMON.
B. Implement monitoring using SNMP or RMON.
C. Poll and record specific SNMP MIB objects from the device.
D. Verify that SNMP MIB is supported in the relevant core device.
A. TCP-based hello packets
B. the impact of flapping links if timers are too low
C. a shared single interface
D. the ability to track serial interfaces
E. UDP-based hello packets
A. Cisco is focusing on Cisco Validated Designs as a means to driving integrated networks.
B. Cisco is focusing on the PIN architecture as a means to driving integrated networks.
C. The Cisco PIN architecture is a critical mechanism for supporting integrated markets because it can be implemented quickly.
D. The Cisco Validated Designs program provides critical mechanisms for supporting integrated markets because the mechanisms can be implemented quickly.
E. Cisco Validated Designs can be implemented quickly without customer input.
A. start LDP
B. enable CEF switching
C. configure the MPLS ID
D. disable IP TTL propagation
E. configure conditional label advertising
F. enable label switching on frame mode interfaces
A. show status
B. show hardware
C. show inventory
D. show environment
A. remote scheduling of software distribution
B. comprehensive logs, reports, and graphs
C. automatic discovery of Cisco WAEs
D. content pre-positioning
A. IS-IS, EIGRP, SSO, BGP
B. ISSU, OSPF, IS-IS
C. IETF, OSPF, ISSU
D. EIGRP, BGP, OSPF, IS-IS
A. An information trap is sent to the SNMP server.
B. Informational and debug messages are logged to the syslog server.
C. All messages are sent to the logging host, where selections are made.
D. All messages from emergencies to informational are sent to the logging host.
A. reset of the primary supervisor
B. manual switchover from standby to active supervisor
C. manual switchover from active to standby supervisor
D. automatic switchover from active to standby on primary supervisor failure
A.Implement
B.Design
C.Prepare
D.Operate
最新試題
You have just reinstalled a VIP 6-80 in a Cisco 7500 Series router. What must you do to bring up the port adapter interfaces?（）
What is the maximum number of Cisco Catalyst 3750 Series Switches that can be united into a single manageable unit using the Cisco StackWise technology?（）
What is the most likely reason that an IBGP route that has been selected as a best route is not entered into the IP routing table?（）
When a Cisco router is configured for SSH, it acts as an （）?
Which description is making sense on the basis of the given information?（）
Which of the following is an easy-to-use tool that allows you to easily configure and monitor Cisco Integrated Services Routers?（）
Refer to the exhibit. Analyze the two traceroutes that are displayed. Which of these statements is correct in describing what most likely caused the traceroute differences?（）
As a network administrator, you issue the interface auto qos voip cisco-phone command on a port in an edge network. It is possible for a Cisco Catalyst switch to check if a Cisco IP Phone is directly attached to that port by:（）
You are an experienced network administrator in an international corporation. During your working hours, you are asked to deploy the Cisco SSL VPN AIM module in a Cisco 1800 Series Router. The beneficial reason for that deployment is to:（）
Referring to the partial Cisco Catalyst switch configuration shown, which two of these statements are correct? （）(Choose two.)