A. reset of the primary supervisor
B. manual switchover from standby to active supervisor
C. manual switchover from active to standby supervisor
D. automatic switchover from active to standby on primary supervisor failure
您可能感興趣的試卷
你可能感興趣的試題
A.Implement
B.Design
C.Prepare
D.Operate
Refer to the exhibit. For interface FastEthernet0/0, what will happen to dscp af11 traffic if thequeue for class "newclass" reaches a depth of 32? ()
A. All packets will be dropped.
B. One out of ten packets will be dropped.
C. A random number of packets will be dropped.
D. No packets will be dropped until the queue depth reaches 40.
E. Packets will be dropped according to the exponential weight setting.
Refer to the exhibit. Users complain that they intermittently lose data and connections toimportant servers. After investigation, you discover that the 802.1Q trunk between DSW111 andASW1 is down. Even though the HSRP group 11 is being serviced by DSW112, you discover thatthe SVI for VLAN 11 is in the up state on DSW111. Which three Cisco Catalyst IOS commands
should you use on DSW111 to find the source of this problem? ()(Choose three.)
A. show vtp status
B. show interfaces vlan 11
C. show standby vlan 11 brief
D. show spanning-tree vlan 11
E. show interfaces
A. This approach separates technologies based on customer buying patterns.
B. This approach integrates solutions by combining technologies that are aligned to customer buying patterns.
C. Although this approach supports verticalization, it is not aligned to partner programs.
D. Although this approach is aligned to partner programs, it does not support verticalization.
最新試題
Referring to the partial Cisco Catalyst switch configuration shown, which two of these statements are correct? ()(Choose two.)
As a network administrator, you issue the interface auto qos voip cisco-phone command on a port in an edge network. It is possible for a Cisco Catalyst switch to check if a Cisco IP Phone is directly attached to that port by:()
What is the function of the no switchport catalyst switch interface configuration command?()
What is the purpose of using VPN hardware acceleration equipment?()
You are trying to initiate an SSH connection to a remote router and are getting rejected with an error code of 0. Which of these might be the cause of the error?()
Which configuration will enable OSPF for IPv6 on FastEthernet 0/0/0?()
What is the most likely reason that an IBGP route that has been selected as a best route is not entered into the IP routing table?()
In a RSTP implementation, which of the following two link types are used? ()(Choose two.)
Refer to the exhibit. Which two of these statements are correct? (Choose two.)()
Refer to the exhibit. You want to minimize the downtime that results from supervisor engine switchovers on Cisco 6500 Series Switches and Cisco 7600 Series Routers. To achieve this, you are considering deploying a Cisco Nonstop Forwarding with Stateful Switchover solution using OSPF.In the exhibit you can see the output of the show ip ospf neighbor detail command.Which trait of systems using Cisco Nonstop Forwarding with Stateful Switchover and OSPF is shown in the exhibit output and will impact your plan?()