A. Cisco is focusing on Cisco Validated Designs as a means to driving integrated networks.
B. Cisco is focusing on the PIN architecture as a means to driving integrated networks.
C. The Cisco PIN architecture is a critical mechanism for supporting integrated markets because it can be implemented quickly.
D. The Cisco Validated Designs program provides critical mechanisms for supporting integrated markets because the mechanisms can be implemented quickly.
E. Cisco Validated Designs can be implemented quickly without customer input.
您可能感興趣的試卷
你可能感興趣的試題
A. start LDP
B. enable CEF switching
C. configure the MPLS ID
D. disable IP TTL propagation
E. configure conditional label advertising
F. enable label switching on frame mode interfaces
A. show status
B. show hardware
C. show inventory
D. show environment
A. remote scheduling of software distribution
B. comprehensive logs, reports, and graphs
C. automatic discovery of Cisco WAEs
D. content pre-positioning
A. IS-IS, EIGRP, SSO, BGP
B. ISSU, OSPF, IS-IS
C. IETF, OSPF, ISSU
D. EIGRP, BGP, OSPF, IS-IS
A. An information trap is sent to the SNMP server.
B. Informational and debug messages are logged to the syslog server.
C. All messages are sent to the logging host, where selections are made.
D. All messages from emergencies to informational are sent to the logging host.
A. reset of the primary supervisor
B. manual switchover from standby to active supervisor
C. manual switchover from active to standby supervisor
D. automatic switchover from active to standby on primary supervisor failure
A.Implement
B.Design
C.Prepare
D.Operate
Refer to the exhibit. For interface FastEthernet0/0, what will happen to dscp af11 traffic if thequeue for class "newclass" reaches a depth of 32? ()
A. All packets will be dropped.
B. One out of ten packets will be dropped.
C. A random number of packets will be dropped.
D. No packets will be dropped until the queue depth reaches 40.
E. Packets will be dropped according to the exponential weight setting.
Refer to the exhibit. Users complain that they intermittently lose data and connections toimportant servers. After investigation, you discover that the 802.1Q trunk between DSW111 andASW1 is down. Even though the HSRP group 11 is being serviced by DSW112, you discover thatthe SVI for VLAN 11 is in the up state on DSW111. Which three Cisco Catalyst IOS commands
should you use on DSW111 to find the source of this problem? ()(Choose three.)
A. show vtp status
B. show interfaces vlan 11
C. show standby vlan 11 brief
D. show spanning-tree vlan 11
E. show interfaces
A. This approach separates technologies based on customer buying patterns.
B. This approach integrates solutions by combining technologies that are aligned to customer buying patterns.
C. Although this approach supports verticalization, it is not aligned to partner programs.
D. Although this approach is aligned to partner programs, it does not support verticalization.
最新試題
Which description is making sense on the basis of the given information?()
What is the function of the no switchport catalyst switch interface configuration command?()
What are four advantages to using tunnel brokers in an IPv6 transition environment?()
With a VPN Accelerator Module 2+ (VAM2+) installed in a Cisco 7200 series router, what will be the resulting action when entering the command no crypto engine accelerator slot number?()
Refer to the exhibit. For the given configuration, on packets leaving the router on interface FastEthernet0/0 that matches the high traffic class, what will the MPLS experimental bit be set to?()
Refer to the exhibit. Analyze the two traceroutes that are displayed. Which of these statements is correct in describing what most likely caused the traceroute differences?()
In a high-availability network, which command, when placed on ports that have connected end stations, will allow you to prevent delays in service for end stations by placing a port in blocking mode?()
Which of the following is an easy-to-use tool that allows you to easily configure and monitor Cisco Integrated Services Routers?()
When a Cisco router is configured for SSH, it acts as an ()?
Which configuration will enable OSPF for IPv6 on FastEthernet 0/0/0?()