You are tasked with designing a security solution for your network.
What information should be gathered prior to designing the solution?()
A.a list of applications currently in use in the network
B.IP addressing design plans so that the network can be appropriately segmented to mitigate potential network threats
C.detailed security device specifications
D.results from pilot network testing
您可能感興趣的試卷
你可能感興趣的試題
You are tasked with designing a security solution for your network.
What information should be gathered prior to designing the solution?()
A.IP addressing design plans so that the network can be appropriately segmented to mitigate potential network threats
B.detailed security device specifications
C.results from pilot network testing
D.results from a network audit
You are tasked with designing a security solution for your network.
What information should be gathered prior to designing the solution?()
A.IP addressing design plans so that the network can be appropriately segmented to mitigate potential network threats
B.a list of the customer requirements
C.detailed security device specifications
D.results from pilot network testing
Cat6500(config)# router ospf 1
Cat6500(config-router)# network 0.0.0.0 255.255.255.255 area 0
Cat6500(config-router)# nsf Cat6500(config-router)#end
Refer to the exhibit. The configuration is used to enable nonstop forwarding for OSPF on a Catalyst 6500 Series
Switch with redundant supervisor engines.
The default CEF configuration is unchanged. After testing, user traffic is interrupted and NSF is not operational.
What is the most likely reason? ()
A.CEF was not properly configured.
B.OSPF was not properly configured for graceful restart.
C.Stateful switchover was not correctly configured.
D.NSF for OSPF is only supported in area 0.
To initiate testing,
which port does a Cisco IOS IP SLA source use to send a control message to an IP SLA responder? ()
A.UDP port 2020
B.UDP port 1967
C.TCP port 2020
D.ICMP port 1967
A.required at the destination to implement Cisco IOS IP SLA services
B.improves measurement accuracy
C.required for VoIP jitter measurements
D.provides security on Cisco IOS IP SLA messages via LEAP or EAP-FAST authentication
E.responds to one Cisco IOS IP SLA operation per port
F.stores the resulting test statistics
A.only implemented between Cisco source and destination-capable devices
B.statistics provided by syslog, CLI, and SNMP
C.measures delay, jitter, packet loss, and voice quality
D.only monitors VoIP traffic flows
E.provides active monitoring
F.provides passive monitoring
A.Test major changes before deployment and defer minor changes until during deployment.
B.Document and verify rollback procedures.
C.Ensure consistency of code versions across the network.
D.Progressively modify procedures and documentation during implementation.
A.work staff attributes, such as skills and communication
B.redundancy, to prevent single points of failure
C.processes, such as documentation, change control, and labs
D.appropriate technology, such as hardware and software
E.tools, such as those for monitoring and reporting
A.pleting aggressive implementation schedule
B.Stateful Switchover
C.pany and user expectations
D.Nonstop Forwarding
E.change control processes
F.dual devices and dual links
A.jitter
B.delay
C.PoE
D.bandwidth
E.packet loss
最新試題
Refer to the exhibit. What command was issued on the Layer 3 switch Sw1 between Exhibit #1 and Exhibit #2?()
Refer to the exhibit. LACP has been configured on Switch1 as shown. Which is the correct command set to configure LACP on Switch2?()
Refer to the exhibit. Switch S2 contains the default configuration. Switches S1 and S3 both have had the command spanning-tree mode rapid-pvst issued on them. What will be the result?()
How are STP timers and state transitions affected when a topology change occurs in an STP environment?()
Refer to the exhibit. Initially, LinkA is connected and forwarding traffic. A new LinkB is then attached between SwitchA and HubA. Which two statements are true about the possible result of attaching the second link?()
Which two statements about the various implementations of STP are true?()
Refer to the exhibit. What does the command channel-group 1 mode desirable do? ()
Refer to the exhibit. All network links are FastEthernet. Although there is complete connectivity throughout the network, Front Line users have been complaining that they experience slower network performance when accessing the server farm than the Reception office experiences. Based on the exhibit, which two statements are true?()
Refer to the exhibit. Which Virtual Router Redundancy Protocol (VRRP) statement is true about the roles of the master virtual router and the backup virtual router?()
Which two statements are true when the extended system ID feature is enabled? ()